Abstract:The purpose of this work is to experimentally assess the application of a hybrid process, Donnan Dialysis (DD)/precipitation, for the selective separation and recovery of Nickel ions from Nickel electroplating rinse bath effluent. The primary objectives include facilitating water and Nickel reuse while protecting environmental resources. The separation of Ni (II) via an ion-exchange membrane was investigated experimentally. Operational parameters, such as the type of cation-exchange membrane, initial Nickel (II) concentration, and counter-ion concentration, were systematically studied to understand their impact on the productivity and selectivity of DD process. Simultaneously, the feasibility and efficiency of Ni (II) recovery from the receiver compartment through the precipitation process, forming Ni 3 (PO 4 ) 2 , were examined. Results indicate that, under optimal conditions and with an initial Ni (II) concentration of 200 mg/L or less, the removal efficiency reached 90% after 24 hours of dialysis. Significantly, the type of cation-exchange membrane emerged as a crucial factor influencing Ni (II) removal. Additionally, employing PO 4 3- as a precipitation reagent in a stoichiometric ratio yielded an excellent Ni recovery performance of 99%. Consequently, the treated effluent (feed compartment) becomes suitable for recycling in a new electroplating operation, while the solution obtained in the receiver compartment can be reused for another DD cycle process after Ni (II) recovery as Ni 3 (PO 4 ) 2 . Importantly, this hybrid method produces a valuable Ni 3 (PO 4 ) 2 precipitate of excellent quality.

An Investigation into Regeneration of Spent Electroless Nickel Plating Bath by Electrodeionization

Removal of Fe Impurity Ions from a Spent Vanadium Electrolyte Using Capacitive Deionization Based on Resin/Activated Carbon Composite Electrodes

SCALING PROBLEM AND PREVENTING MEASURES OF ELECTRODEIONIZATION PROCESS

A Comparative Study Of Nickel(Ii) Removal From Electroplating Wastewater By Pre-Precipitation Combined With Fenton-Precipitation Or Fenton-Like-Precipitation

Study on the performance of EDI device in dealing with Ni2+solution with dilute departments filled with cation exchange resins

Removal of Nickel from Spent Electroless Nickel-Plating Bath with Nickel Foam Cathode

Experimental study on the treatment of highly concentrated electroplating nickel-containing waste liquid by electrolytic method

Removal of low concentrations of nickel ions in electroplating wastewater by combination of electrodialysis and electrodeposition

TREATMENT AND REUSE OF NICKEL PLATING RINSING WATER BY ION EXCHANGE PROCESS

Removal of Low Concentrations of Nickel Ions in Electroplating Wastewater Using Capacitive Deionization Technology.

Influence of Some Parameters on Membrane-Free Electrodeionization for the Purification of Wastewater Containing Nickel Ions

Membrane-free Electrodeionization for Purification of Wastewater Containing Low Concentration of Nickel Ions

Recovery of Ni(II) from Real Electroplating Wastewater Using Fixed-Bed Resin Adsorption and Subsequent Electrodeposition

Simultaneous Removal of Nitrate and Hardness Ions from Groundwater Using Electrodeionization

Reconditioning of Electroless Nickel Plating Bath on Magnesium Alloys

Industrial-scale highly efficient nickel recovery from electroplating wastewater using resin adsorption followed by aeration mixing acid regeneration

Research on optimization and efficiency of ion exchange resin for Ni2+removal

The Application of Electrodialysis to Extend the Lifetime of Commercial Electroplating Baths

Using Electrode Electrolytes to Enhance Electrokinetic Removal of Heavy Metals from Electroplating Sludge

Selective recovery of Nickel from electroplating rinse bath wastewater by an integrated Donnan Dialysis/precipitation process

Recovery of nickel from electroless nickel plating wastewater based on the synergy of electrocatalytic oxidation and electrodeposition technology