Abstract:In order to prepare black silicon material with excellent optical absorption performance for solar cell application, a micro/nano bilayer-structure is formed on the surface of textured silicon wafer by a silver assisted chemical etching method. It is found that the deeper nanoholes could form as the etching time is longer, and the surface reflectivity is reduced obviously due to the increased time of photon reflection from the nanowires. The incident light reflectivity of the prepared black silicon is significantly reduced to 2.3%, showing obviously better optical reflectance characteristics than general monocrystalline silicon wafer, especially in a wavelength range of 300-830 nm. Considering the fact that a large number of carrier recombination centers is introduced into the nanostructured crystal silicon surface, BiFeO3/ITO composite film is coated on the surface of the black silicon solar cell by magnetron sputtering process to optimize the surface defect states and improve the cell performance. The experimental results show that the lengths of the nanowires are predominantly in a range of 180-320 nm for the prepared black silicon with micro/nano double-layer structure. The reflectivity of the incident light is below 5% in a wavelength range from 300 nm to 1000 nm, and reaches a maximal value at about 700 nm. The reflectance increases slightly as BiFeO3/ITO composite film is coated on the surface of black silicon solar cell, but it is still much lower than that of general monocrystalline silicon solar cell. The open circuit voltage and short circuit current density of the black silicon solar cell increase respectively from 0.61 V to 0.68 V and from 28.42 mA/cm2to 34.57 mA/cm2after it has been coated with BiFeO3/ITO composite film, and the photoelectric conversion efficiency of the cell increases from 13.3% to 16.8% accordingly. The improvement in performance of black silicon solar cell is mainly due to the promotion of effective separation of photogenerated carriers, thereby enhancing the spectral response of black silicon solar cell in the whole wavelength range. This indicates that the spontaneously polarized BiFeO3film can play a better role in improving the surface properties of black silicon solar cell. On the other hand, for the BiFeO3film deposited on the surface of black silicon, a spontaneous polarization positive electric field could be produced, pointing from the film surface to the inside of the solar cell. This polarization electric field could also act as part of built-in electric field to contribute the photoelectric transformation of the black silicon solar cell, leading to the open circuit voltage of cell increasing from 0.61 V to 0.68 V. © 2017 Chinese Physical Society.

Effect of dc negative-bias and silicon introduction on performance of Si?B?N composite film by RF-PECD technique

Electrical and Optical Properties of Boron‐doped Nanocrystalline Silicon Films Deposited by PECVD

PREPARATION OF SiC-B4C COMPOSITE FILM AND ITS MECHANICAL AND THERMOELECTRIC PROPERTIES

Experimental Approach to the Mechanism of the Negative Bias Enhanced Nucleation of Diamond on Si Via Hot Filament Chemical Vapor Deposition

Influence of Boron-doping on Electrical Properties of Na-Si:H Thin Film Prepared by PECVD

The Location and Doping Effect of Boron in Si Nanocrystals Embedded Silicon Oxide Film

The Effect of DC Voltage during Bias-Enhanced Nucleation Treatment on Diamond Film Growth

Effects of C/Si ratios on structures and behaviors of NbSiCN nanocomposite films synthesized by reactive magnetron sputtering

Doping Effects in Co-deposited Mixed Phase Films of Hydrogenated Amorphous Silicon Containing Nanocrystalline Inclusions

Fluorine IMP effect on negative bias temperature instability and process induced defects

Factors for Negative Bias Temperature Instability Improvement in Deep Sub-Micron CMOS Technology

Negative substrate bias induced modifications of the physical properties of DC sputter deposited nano-crystalline Mo thin films

Effect of BN interfacial layer on the mechanical behavior of SiC fiber reinforced SiC ceramic matrix composites

Effects of silicon content on the structure and mechanical properties of (AlCrTaTiZr)–Si<sub><i>x</i></sub>–N coatings by reactive RF magnetron sputtering

Effects of Silicon Incorporation on Composition, Structure and Electric Conductivity of Cubic Boron Nitride Thin Films

Effect of PyC/BN interfacial phases on mechanical behavior of SiC/SiC composites

Performance investigation of black silicon solar cells with surface passivated by BiFeO3/ITO composite film

Effects of Nitrogen Impurities on the Microstructure and Electronic Properties of P-Doped Si Nanocrystals Emebedded in Silicon-Rich Sinx Films

Significant Lifetime Improvement of Negative Bias Thermal Instability by Plasma Enhanced Atomic Layer Deposition SiN in Stress Memorization Technique

Influence Mechanism of RF Bias on Microstructure and Superconducting Properties of Sputtered Niobium Thin Films

The Effect of Gradient Bias Design on Electrochemistry and Tribology Behaviors of PVD CrN Film in a Simulative Marine Environment