Abstract:Nitrogen-doped SiC microparticles (SiCp) and SiC nanowries (SiCNWs) with different nitrogen contents were successfully synthesized by a simple and effective method, in which SiCp and SiCNWs were directly annealed in N-2 at 1500 degrees C with different holding times to adjust the contents of nitrogen for the first time. The nitrogen content of N-doped SiCp and SiCNWs increased with holding time, from 2.91 at.% and 3.05 at.% for 1 h to 5.05 at.% and 5.25 at.% for 4 h. The size of N-doped SiCp and SiCNWs was larger than that of pristine SiCp and SiCNWs, while the size tended to increase firstly and then decrease. The results of dielectric parameters showed that both real part epsilon' and imaginary part epsilon" of permittivity of the samples increased greatly with increasing N contents in most frequency range, while two opposing trends for nitrogen content dependent microwave absorption property of N-doped SiCp and SiCNWs were observed. The electromagnetic (EM) wave absorption capability of N-doped SiCp was significantly improved with increasing nitrogen content compared with fully permeable wave pristine SiCp, and the minimum reflection loss (RLm) and maximum effective absorption bandwidth (EAB) could be up to -33.5 dB and 4.4 GHz, respectively. The EM wave absorption performance of N-doped SiCNWs exhibited a decreasing tendency with increasing nitrogen content, and the RLm was decreased from -57 dB for pristine SiCNWs, to -51.2 dB for SiCNWs with 3.05 at.% N, and to -29.3 dB for SiCNWs with 5.25 at.% N. Moreover, if the experimental process in present study was decomposed into heat-treatment and N-doping, the heat-treatment played extremely negative effect on the EM wave absorption performance of samples, while N-doping still had positive impact on the EM wave absorption performance. It is believed that the current work will provide a new insight into the fabrication of SiC materials with fascinating properties by doping. (C) 2018 Elsevier B.V. All rights reserved.

Research on Nitrogen Implantation Energy Dependence of the Properties of SIMON Materials

Nitrogen Ion-implantation in Silicon

Energy Dependence of Low Dose SIMOX Wafers

Nitrogen Enhanced Oxygen Precipitation in Czochralski Silicon Wafers Coated with Silicon Nitride Films

Influence of ion implantation on properties and structure of silicon nitride

Research on Ion Implantation in MEMS Device Fabrication by Theory, Simulation and Experiments

Nitrogen Content Dependent Microwave Absorption Property of Nitrogen-Doped SiC Materials Annealed in N-2: Opposing Trends for Microparticles and Nanowires

Effects of Thermal Annealing on the Properties of N-Implanted Zns Films

Nitrogen investigation by SIMS in two wide band-gap semiconductors: Diamond and Silicon Carbide

Effects of N‐Ion Implantation on the Electrical and Photoelectronic Properties of MoS2 Field Effect Transistors

The Microstructure, Optical and Magnetic Property of Nitrogen Implanted Sio2

Research on dopant distribution of multi-energy boron implantations into c-SiC

Bonding and Diffusion of Nitrogen in the Insbn Alloys Fabricated by Two-Step Ion Implantation

Electrical Properties of Insbn Alloys Fabricated by Two-Step Ion Implantation

Computer Simulation for the Formation of the Insulator Layer of Silicon-On-Insulator Devices by N+ and O+ Co-Implantation

Influence of implantation conditions on quality of SIMOX materials

Effects of Nitrogen Implantation into Gate Electrode on Characteristics of Ultra-Thin Gate Oxide

Effects of different fabrication processes on stress of SIMOX structure

Nitrogen Ion Implantation on the Mechanical Properties of Aisi 420 Martensitic Stainless Steel

Slow Positron Beam Study of Nitrogen Implanted CZ-Si Subjected to Rapid Thermal Processing

Study of Annealing Condition of InSbN Alloys Fabricated by Ion Implantation