Abstract:A new in situ multi-phase composite based on intermetallic TiAl is successfully reaction-synthesized from elemental powder mixtures of Ti, Al, TiO2 and C using hot-pressing-aided reaction synthesis technique (HPRS). The microstructure, flexural strength as well as fracture toughness of the monolithic TiAl-based compound and in situ composites are investigated. The products are mainly composed of Al2Ti4C2, TiC, Al2O3, Ti3Al and TiAl whereas Al3Ti is formed in case the starting powder mixtures contain more excess amount of Al. It is found that the formed fine Al2O3 and TiC particles tend to disperse on the grain boundaries. Although all of the three materials exhibit a typical brittle fracture mode, the fracture toughness of the in situ composites is substantially higher than that of the monolithic TiAl-based alloy by about 40–60% increase due to the toughening effect arising from interaction between the crack tip and the microstructures. However, the existence of residual porosity in the in situ composite samples in case of low external pressure applied to compacts during the reaction synthesis process results in insuperior flexural strength to that of the TiAl-based monolithic.

Preparation of Al<sub>2</sub>O<sub>3</sub>/TiSiC<sub>2</sub> Multilayer Materials by In-Situ Synthesis

Preparation of Al2O3/Ti3SiC2 multilayer materials by in-situ synthesis

Preparation and Properties of Al2O3/Ti3SiC2 Multilayer Materials

In Situal3ti–al2o3 Intermetallic Matrix Composite: Synthesis, Microstructure, and Compressive Behavior

The interface-layer and interface in the Al2O3/Ti3SiC2 multilayer composites prepared by in situ synthesis

Ultra-toughened Al2O3–TiC–Co ceramic

Preparation and Properties of Ternary Ti3AlC2 and Its Composites from Ti–Al–C Powder Mixtures with Ceramic Particulates

Preparation and properties of Al2O3/Al-2(1-0.2)Mg0.2Ti(1+0.2)O5 matrix ceramic composite

Microstructural characterization and mechanical properties of TiAl–Al2Ti4C2–Al2O3–TiC in situ composites by hot-press-aided reaction synthesis

Microstructure and Mechanical Properties of Ti2AlC-reinforced TiAl Composites

Processing, Microstructural Characterization and Mechanical Properties of in Situ Ti3AlC2/TiAl3 Composite by Hot Pressing

Synthesis and Mechanical Properties of In-Situ Hot-Pressed Ti3SiC2 Polycrystals

Microstructure and mechanical properties of Ti3(Al,Ga)C2/Al2O3 composites prepared by in situ reactive hot pressing

Mechanical Properties and Microstructure of Al<sub>2</sub>O<sub>3</sub>-Ti<sub>3</sub>SiC<sub>2</sub> Ceramic Composites

Mechanical Properties of (ti2alc+ti3alc)–tial Ceramic–intermetallic Laminate (CIL) Composites

Fabrication and properties of Ti3AlC2-based ceramics by two-step method

Fabrication of Al2O3–Ti3SiC2 Composites and Mechanical Properties Evaluation

In Situ Synthesis and Properties of Ti<sub>3</sub>AlC<sub>2</sub>/TiB<sub>2</sub> Composites

Preparation and characteristics of Ti3AlC2 -Al3Ti/Al composite materials synthesized from pure Al and Ti3AlC2 powders

Improvement of mechanical properties of Al2O3/Ti3SiC2 multilayer ceramics by adding SiC whiskers into Al2O3 layers

Fabrication and Properties of Ti<sub>3</sub>AlC<sub>2</sub>-Based Ceramics by Two-Step Method