Abstract:Abstract Layer-structured interphase, existing between reinforcing fiber and ceramics matrix, is an indispensable constituent for fiber-reinforced ceramic composites due to its determinant role in the mechanical behavior of the composites. However, the interphase may suffer high residual stress because of the mismatch of thermal expansion coefficients in the constituents, and this can exert significant influence on the mechanical behavior of the composites. Here, the residual stress in the boron nitride (BN) interphase of continuous SiC fiber-reinforced SiC composites was measured using a micro-Raman spectrometer. The effects of the residual stress on the mechanical behavior of the composites were investigated by correlating the residual stress with the mechanical properties of the composites. The results indicate that the residual stress increases from 26.5 to 82.6 MPa in tension as the fabrication temperature of the composites rises from 1500 to 1650 °C. Moreover, the increasing tensile residual stress leads to significant variation of tensile strain, tensile strength, and fiber/matrix debonding mode of the composites. The sublayer slipping of the interphase caused by the residual stress should be responsible for the transformation of the mechanical behavior. This work can offer important guidance for residual stress adjustment in fiber-reinforced ceramic composites.

Residual stress analysis in the Al2O3/Ti 3SiC2 multilayer composites

The interface-layer and interface in the Al2O3/Ti3SiC2 multilayer composites prepared by in situ synthesis

Thermal residual stress in continuous SiC fiber reinforced titanium matrix composites

Preparation of Al2O3/Ti3SiC2 multilayer materials by in-situ synthesis

Experimental study of residual stress distribution in interfacial micro-region of SiC f /Ti17 composites via micro-slotting method

Reaction mechanism and microstructure evolution of superhigh strength in-situ TiC/Ti composite based on Cr 2 AlC-Ti system

Mechanical properties and microstructure of a Si3N4/Ti3SiC2 multilayer composite

Micromechanical Analysis of SiC/Ti6Al4V Composite Under Complex Stress State

Numerical Analysis of the Effects of Reinforcing Particles on the Residual Stress of TiB2/Al-Si Composites Fabricated by Laser Powder Bed Fusion

Effects of Ti3SiC2 on microstructure and properties of TiC0.4 enhanced TiAl matrix composites

Residual stress variation in SiCf/SiC composite during heat treatment and its effects on mechanical behavior

R-curve Behavior of TiC Particle Reinforced Al2O3 Composites

A Study of the Residual Stress and Its Influence on Tensile Behaviors of Fiber-Reinforced Sic/Al Composite

Effects of interfacial residual stress on mechanical behavior of SiCf/SiC composites

Preparation of Al<sub>2</sub>O<sub>3</sub>/TiSiC<sub>2</sub> Multilayer Materials by In-Situ Synthesis

Tribological properties and microstructures of Al2O3-TiC-TiB2 reinforced composites

Effect of residual stresses on the mechanical properties of Ti-TiAl laminate composites fabricated by hot-pack rolling

Anisotropic microstructures and mechanical properties of textured Ti3AlC2/TiAl3/Al composite

Fabrication, microstructure and mechanical properties of TiAl matrix composite reinforced by submicro/nano-Ti 2 AlC

Preparation and Properties of Al2O3/Ti3SiC2 Multilayer Materials

Compressive performance and crack propagation in Al alloy/Ti2AlC composites