Abstract:A self-consistent diffusion model has been employed to simulate the atomic nitrogen transport in titanium alloy with the coupling effect of both initial activated nitrogen concentration and high temperature gradient. Transport equations are solved through coupling the transient heat transfer equation and incorporating the surface physical phenomena in the governing equations as boundary conditions. For comparisons, laser gas nitriding of Ti6Al4V alloy has been performed by means of a pulsed Nd:YAG laser irradiation in a controlled nitrogen chamber. Results indicate that the simulated nitriding molten pool geometry and nitrogen concentration profiles are broadly consistent with the experimental results for various laser intensities and nitrogen pressures. Due to the combined driving of both concentration and temperature gradient, a rapid increase of nitrogen concentration profile during the heating stage is observed. While in the cooling stage, the redistribution of nitrogen in substrate and the local maximum of nitrogen close to the surface are mainly caused by the transient temperature gradient which is confirmed by both the experimental and simulated results. In addition, the influence of laser intensity on nitrogen transport is strongly related to the initial nitrogen concentration at surface. Especially, when the initial nitrogen concentration at surface approaches to the maximum concentration limit of nitrogen in titanium nitrided layer, slight drops of nitrogen concentration in molten zone are observed with the increase of laser intensity. This indicates that the earlier formed diffusion barrier due to the maximum concentration limit will impede the further penetration of atomic nitrogen and thus lead to the relatively lower concentration.

Surface nitridation of transition metals by pulsed laser irradiation in gaseous nitrogen

Surface nitridation of molybdenum by laser-promoted reaction

Preparation of molybdenum nitrides by laser-promoted nitridation reaction

SURFACE NITRIDATION OF MOLYBDENUM BY PULSE LASER

Surface nitridation of titanium using pulse laser gas alloying method and its microstructure analysis with XRD and SEM

Investigation on Surface Nitridation of Titanium by Pulsed Laser

Comparison of open-atmosphere nitriding on various metal surfaces triggered by a focused pulsed laser irradiation

Laser Surface Nitriding of Ti–6Al–4V Alloy in Nitrogen–Argon Atmospheres

Mass Transport in Laser Surface Nitriding Involving the Effect of High Temperature Gradient: Simulation and Experiment

Reactions of Laser-Ablated Niobium, Tantalum, and Rhenium Atoms with Nitrogen Atoms and Molecules. Infrared Spectra and Density Functional Calculations of the Metal Nitride and Dinitride Molecules

Laser nitriding of titanium surface and TOFMS (time of fight mass spectra) analysis

Enhancement of the properties of pulsed laser-deposited carbon nitride by the synchronisation of laser and N2 gas jet pulses

Microstructure evolution and mass transfer behavior during multi-pass laser surface nitriding process on titanium alloy

Research on Technology of Laser Gas Nitriding on TA2 Pure Titanium Surface

Microstructure and Hardness of the Laser Surface Treated Titanium

Gaseous Nitriding Process of Surface Nano Crystallized (snced) Steel

Investigation of nitrogen ionization state and its effect on the nitride layer during fiber laser gas nitriding of Ti-6Al-4V alloy

Improved Nitrogen Transport in Surface Nanocrystallized Low-Carbon Steels During Gaseous Nitridation

Reactions of Laser-Ablated Niobium and Tantalum Atoms with NO. Infrared Spectra of the NMO, M(η-NO)x (x = 2, 3), and (N2)(MO2) Molecules in Solid Argon

Formation of Titanium Nitride, Titanium Carbide, and Silicon Carbide Surfaces by High Power Femtosecond Laser Treatment

Microstructure evolution and vacuum tribological properties of surface nitriding layer on a TiZrAlV alloy fabricated by laser nitriding