Abstract:Nowadays, surface engineering focuses on research into materials for medical applications. Titanium and its alloys are prominent, especially Ti-6Al-4V and Ti-13Nb-13Zr. Samples made of pure grade IV titanium and the titanium alloys Ti-6Al-4V and Ti-13Nb-13Zr were modified via laser treatment with laser beam frequency f = 25 Hz and laser beam power P = 1000 W during a laser pulse with duration t = 1 ms. Subsequently, to analyze the properties of the obtained surface layers, the following tests were performed: scanning electron microscopy, chemical and phase composition analysis, wetting angle tests and roughness tests. The assessment of the impact of the laser modification on the internal stresses of the investigated materials was carried out by comparing the values of the stresses of the laser-modified samples to those of the reference samples. The obtained results showed increased values of tensile stresses after laser modification: the highest value was found for the Ti-6Al-4V alloy at 6.7434 GPa and the lowest for pure grade IV titanium at 3.742 GPa. After laser and heat treatment, a reduction in the stress was observed, together with a significant increase in the hardness of the tested materials, with the highest value for Ti-6Al-4V alloy at 27.723 GPa. This can provide better abrasion resistance and lower long-term toxicity, both of which are desirable when using Ti-6Al-4V and Ti-13Nb-13Zr alloys for implant materials.

Microstructure and Hardness of the Laser Surface Treated Titanium

Microstructural Characterization of Pure Titanium Treated by Laser Surface Treatment under Different Processing Parameters

Microstructure characterization and evolution mechanism of titanium during laser surface nitriding

Plasma Nitridation and Mechanical Properties of Pure Titanium Casts

Enhancing the corrosion properties and microhardness of titanium alloy by laser surface remelting

TiC/Ti Composite Layers Fabricated by Laser Surface Alloying

Laser Surface Modification Of Titanium Alloys - A Review

Microstructure evolution and mass transfer behavior during multi-pass laser surface nitriding process on titanium alloy

Microstructure and Properties of Ti6Al4V Surface Processed by Continuous Wave Laser in Different Atmospheres

Laser nitridation on Ti-6.5Al-3.5Mo-1.5Zr-0.3Si titanium alloy

Influence of laser treatment on the microstructural evolution and performance of Ti65 alloy

Surface nitridation of titanium using pulse laser gas alloying method and its microstructure analysis with XRD and SEM

Laser Surface Alloying of Pure Titanium with TiN–B–Si–Ni Mixed Powders

Surface Modification of Pure Ti by Laser Alloying with B and Ni Mixed Powders

Microstructure and Wear Resistance of a Laser Surface Alloyed γ-TiAl Intermetallic Alloy Ti-48Al-2Cr-2Nb

Laser Surface Treatment of VT6 and VT23 Titanium Alloys

Investigation on Surface Nitridation of Titanium by Pulsed Laser

Research on Technology of Laser Gas Nitriding on TA2 Pure Titanium Surface

Progress in Laser Surface Modification Technology of Titanium Alloy

Enhancing Hardness and Wear Performance of Laser Additive Manufactured Ti6Al4V Alloy Through Achieving Ultrafine Microstructure

Mechanical Properties and Residual Stress Measurements of Grade IV Titanium and Ti-6Al-4V and Ti-13Nb-13Zr Titanium Alloys after Laser Treatment