Abstract:Anomalous structural evolution was induced by room-temperature 200 keV xenon ion irradiation and it results in the formation of various new metastable phases in the equilibrium immiscible Fe–Cu system. First, nanosized quasicrystals were formed in an amorphous matrix through a two-step transition of crystal to amorphous to quasicrystal in Fe70Cu30 multilayered films. The real compositions of the amorphous matrix and quasicrystals were determined to be close to Fe70Cu30 and Fe50Cu50, respectively. Moreover, the same icosahedral phase was also obtained in another similarly designed Fe50Cu50 multilayered sample upon 850 °C thermal annealing, confirming the existence of such a metastable state. Second, amorphous alloys were formed in a composition range of 30–50 at. % of Cu. Third, a Cu-based face-centered-cubic (fcc) solid solution was formed at an alloy composition of about Fe30Cu70 and, interestingly, another fcc structured metastable crystalline phase was obtained at a composition very close to that of Fe50Cu50. A Gibbs free energy diagram of the Fe–Cu system was calculated, with special consideration of excess interfacial free energy stored in the multilayered films, within the framework of Miedema’s model and it gives a reasonable thermodynamic explanation to the metastable phase formation observed. The amorphous-to-quasicrystal transition is also discussed in terms of the similarity in the atomic configuration between the icosahedral and amorphous short-range orders. Furthermore, molecular dynamics study showed that Fe and Cu could be mixed on an atomic scale in the metastable phases observed.

METASTABLE PHASES IN VAPOR-QUENCHED AL78CU22 FILM

Evaporated CuAl Amorphous Alloys and Their Phase Transition

Metastable Phases Induced by Ion Irradiation in the Equilibrium Immiscible Fe–Cu System

Structural Phase Evolution in the Equilibrium Immiscible Co–Cu System Studied by Solid-State Reaction/Ion Beam Mixing of Nano-Sized Multilayers

Metastable phase formation in an immiscible Cu-Ta system studied by ion-beam mixing, ab initio calculation, and molecular dynamics simulation

Metastable Phases in Co–Ag System Formed by Ion Beam Assisted Deposition at the Glancing Ion Incidence

The phase transition and microstructure of Fe-Co-B alloy films

Formation of Quasicrystalline Phases in the Equilibrium Immiscible Co-Cu and Fe-Cu Systems by Ion Mixing/Solid-State Reaction

Metastable Phase Formation in the Immiscible Cu–Co System Studied by Thermodynamic, Molecular Dynamics Andab Initiocalculations Together with Ion Beam Mixing

Phase separation of a supersaturated nanocrystalline Cu Co alloy and its influence on thermal stability

The competing crystalline and amorphous solid solutions in the Ag–Cu system

Microstructures and Mechanical Properties of (Alcocrfemn)(100-X)cu-x High-Entropy Alloys

Anomalous phase transformation in magnetostrictive Fe81Ga19 alloy

Phase Transformation Behavior of a Β-Solidifying Γ-Tial-based Alloy from Different Phase Regions with Various Cooling Methods

Metastable phase formation in the immiscible Cu–Co system studied by thermodynamic, molecular dynamics and ab initio calculations together with ion beam mixing

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys

Alloying In An Immiscible Cu-Nb System Upon Solid-State Reaction

Precipitation behavior in the early stage of aging in an Al–Li°Cu–Mg–Zr–Ag (Weldalite 049) alloy

Low Temperature Phase Transformations in Copper-Quenched Ti-44.5Al-8Nb-2.5V Alloy.

Nonequilibrium Alloy Formation In The Immiscible Cu-Mo System Studied By Thermodynamic Calculation And Ion Beam Mixing

Phases Formation and Evolution at Elevated Temperatures of Al–12Si–3.8Cu–2Ni–1Mg Alloy†