Abstract:The study investigates the role of different laser energy densities on the micro-structural evolution in the laser surface re-melted as-cast Zr-8 wt% Cu alloy. In the current study, different values of laser energy density was achieved by varying the scan speeds. The micro-structural investigation of the laser re-melted regions were carried out using Optical microscope, FESEM (Field Emission Scanning Electron Microscope) in back-scattered mode and TEM (Transmission Electron Microscope). The compositional evolution in the laser re-melted regions was carried out using EDS (Energy Dispersive Detector) attached to FESEM and TEM. The mechanical property of the re-melted regions was estimated using nano-indentation technique. The micro-structural examination showed that the laser re-melting of as-cast dendritic morphology leads to the development of < 200 nm Zr and Cu rich regions. The TEM-SAD analysis revealed the formation of amorphous Zr–Cu metallic glass in the laser re-melted regions. It was also observed that the fraction of Cu in the amorphous phase reduces with decrease in laser energy density which is attributed to enhanced solute trapping of Cu in β-Zr phase at higher scan speeds which was shown using Scheil solute trapping model of Thermocalc. The laser re-melted regions developed at high laser energy density shows superior values of nano-hardness and elastic modulus as compared to regions developed at lower laser energy density. This is attributed to higher concentration of Cu in Zr–Cu amorphous phase in laser re-melted regions developed at high laser energy density.

Microscopy study of laser-induced phase change in Al-Cu film

Atomic-Level Study of A Thickness-Dependent Phase Change in Gold Thin Films Heated by an Ultrafast Laser

Femtosecond Laser-Induced Phase Transformations In Amorphous Cu77ni6sn10p7 Alloy

Structure and Reflective Properties of Al-Cu-Fe Quasicrystalline Thin Film Prepared by Laser Induced Arc Method

Evaporated CuAl Amorphous Alloys and Their Phase Transition

METASTABLE PHASES IN VAPOR-QUENCHED AL78CU22 FILM

Microstructure and Tribological Properties of Plasma Sprayed Al–Cu–Fe Quasicrystalline Coatings after Laser Post-Treatment Processing

Nonequilibrium Phase Change in Gold Films Induced by Ultrafast Laser Heating.

Unidirectional Crystal Orientation of Dual-Phase Ni3Al-Based Alloy via Laser Irradiation

Hybrid laser micro/nanofabrication of phase change materials with combination of chemical processing

Preparation of coatings containing Al-Cu-Cr quasicrystal and approximate phases by laser cladding

Structure and phase transformations of amorphous-nanocrystalline Al-based alloy

Transmission Electron-Microscopy Study of Small-Angle Grain-Boundaries, Dislocations and Modulated Phases in Al-Li-Cu Quasi-Crystals

Studying the Effects of Doping Minor Transition Metal Elements in Al-Cu-Fe-Mn Quasicrystals on the Structure and Phase Change of Quasicrystals

Thermomechanical response and strengthening effect of femtosecond laser-irradiated CoCrFeNi high-entropy alloy films

Study of structural phase transition in nanocrystalline Cobalt Oxide thin films by pulsed laser deposition

Magneto-optical Control of Ordering Kinetics and Vacancy Behavior in Fe-Al Thin Films Quenched by Laser

Ultrafast melting, spallation, and phase explosion in femtosecond laser processing on nickel film surface investigated by atomistic simulation and transient reflectivity microscopy

Ultrafast atomic view of laser-induced melting and breathing motion of metallic liquid clusters with MeV ultrafast electron diffraction

Effect of Laser Energy Density on Phase Evolution in Laser Surface Melted As-Cast Zr–Cu Alloy