Abstract:Improved heat dissipation performance, by way of thermal management, is critical in many engineering applications. In this study, three types of silane coupling agents were used to modify aluminum nitride (AlN) powder for vat photopolymerization. The effect of silane coupling agents on the rheology, stability, and curing behavior were systematically studied. The results showed that, compared with two other types of silane coupling agents, one silane agent (KH570) had a larger positive effect on the rheology and stability of the AlN suspension, and the absorbance of the AlN powder increased after surface modification. In addition, the effects of different solid loadings on the curing behavior and CC double-bond conversion rate were systematically investigated. It was found that a higher solid loading resulted in a lower curing depth, cure width, and CC double-bond conversion rate. For the sintered AlN components with increased solid loading, the shrinkage decreased while both the flexural strength and thermal conductivity increased. In addition, the shrinkage in the Z-direction was higher than that in the X- and Y-directions. Scanning electron microscopy analysis showed that the mean grain size decreased with increasing solid loading. Furthermore, a heat dissipation performance evaluation system was designed to illustrate the heat transmission capacity of AlN ceramics. Simulation and experimental results showed that AIN ceramic parts with complex shapes achieved better heat-dissipation performance than those with simple shapes.

Structure and thermal conductivity of powder injection molded AlN ceramic

Effect of powders on aluminum nitride components fabricated by PIM

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Preparation of AlN microspheres/UHMWPE composites for insulating thermal conductors

Microstructure and thermal conductivity of AlN ceramics with ultra-fine Y2O3 powder addition

Effects of Y2O3 and Yttrium Aluminates As Sintering Additives on the Thermal Conductivity of AlN Ceramic Substrates

Additive manufacturing of complex-shaped and high-performance aluminum nitride-based components for thermal management

Optimization Of Non-Aqueous Tape Casting Of High Solid Loading Slurry For Aluminum Nitride Ceramic Substrates

Thermal Properties of Mg–Al/AlN Composites Fabricated by Powder Metallurgy

Structure and Properties of Aln Ceramics Prepared with Spark Plasma Sintering of Ultra-Fine Powders

Characterization of shock waves treated aluminum nitride powder and its potential for low-temperature sintering

High-Thermal-Conductivity AlN Ceramics Prepared from Octyltrichlorosilane-Modified AlN Powder

High-performance aluminum nitride made by Vat photopolymerization through optimization of resin refractive index and plasticizer content

Thermal conductivities and mechanical properties of AlN ceramics fabricated by three dimensional printing

Fabrication and characterization of aluminum nitride polymer matrix composites with high thermal conductivity and low dielectric constant for electronic packaging

Thermal and Dielectric Properties of the AlN Particles Reinforced Linear Low-Density Polyethylene Composites

SPARK PLASMA SINTERING OF AlN POWDERS OBTAINED FROM COMBUSTION SYNTHESIS AND THEIR THERMAL CONDUCTIVITY

Effect of surface modification of aluminum nitride on electrical and thermal characterizations of thermosetting polymeric nanocomposites

Crystallization of Polyphenylene Sulfide Reinforced with Aluminum Nitride Composite: Effects on Thermal and Mechanical Properties of the Composite

Optimizing AlN hydrolysis process to fabricate coated modified powders for improving the properties of Si 3 N 4 /SiAlON ceramics prepared by Vat Photopolymerization

Balancing thermal conductivity and strength of hot-pressed AlN ceramics via pre-sintering and annealing process