Abstract:The Pb0.4Sr0.6TiO3 (PST) thin films with the perovskite phase were fabricated successfully on ITO/glass substrates by the sol-gel method with rapid thermal processing (RTP) above 500degreesC. The crystalline phase structures and the surface morphologies of the thin films were measured through XRD, SEM and AFM respectively. Results show that both the formation of the perovskite and contents of the crystalline phase in this PST thin film are dependent on the preparing process and the activity of ions in the formation of the crystalline phase. By RTP, high active ions obtained in the gel decomposition directly form the crystalline phase, and consequently, much more contents of the crystalline phase can be obtained even at a relatively lower temperature. 14% more contents of crystalline phase appear in RST thin film at 600degreesC by RTP than by heat treatment at 600degreesC for a long time. The lowest temperature of forming of the proveskite phase in sol-gel derived PST thin film is approximately 500degreesC by RTP, which is 50degreesC lower than that by heat treatment for a long time. The surface morphology of the thin film is related to the heat treatment processing. By RTP the surface morphology of the thin film keeps the original state, where the actual smooth exhibits the noncrystalline thin film and the hill-like protuberance shows the well crystalline one. Due to etching under the oxygen atmosphere at high temperature, the thin film calcined for a long time contributes the morphology with uniformly dispersed micro conical cylinders all over the surface on the basis of the original smooth or hill-like surface state.

Crystallization Process and Microstructure of Sol–gel Derived Pb0.9La0.1Ti0.875O3 Fine Fibers with a Novel Heat-Treatment Process

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Effect of KOH Concentration on the Phase and Morphology of Hydrothermally Synthesized Pb0.70La0.30TiO3 Fine Powders

Effects of heat treatment on the formation of sol-gel derived Pb0.4Sr0.6TiO3 thin films

Effect of La-Introduced Manner on the Phase Formation and Morphology of the Hydrothermally Synthesized Pb_(0.70)La_(0.30)TiO_3 Powders

Exploration of single-crystal like electrospun Pb(Zr_(0.52)Ti_(0.48))O_3 nanofibers synthesis via electrospinning

Hydrothermally synthesized Pb0.70La0.30TiO3 powders

Preparation on the [(Pb,La) (Zr,Ti)O3] ferroelectric thin films by using the Sol-Gel processing

Hydrothermal Synthesis and Photoluminescence of Pre-Perovskite Lead Titanate Nanofibers

Structural and Phonon Characteristics of PbxLa1−xTiO3 Nanocrystals Prepared by Hydrothermal Technique

Structure evolution and thermal stability of La_2O_3-doped mullite fibers via sol-gel method

Growth, structure, and morphology of lead titanate crystallites in the sol-gel derived glass—ceramics

Crystallization, phase evolution and ferroelectric properties of sol-gel-synthesized Ba(Ti0.8Zr0.2)O3-x(Ba 0.7Ca0.3)TiO3 thin films

Study on Properties of Pb_(1-x)La_xTiO_3 Thin Films Prepared by Sol -Gel

Structure and properties of PLT(28) thin films with nano-grain

Low Temperature Preparation and Electric Properties of Highly (100)-Oriented Pb0.8 La0.1Ca0.1Ti0.975O3 Thin Films Prepared by a Sol–gel Route

Pressureless Sintering of Al-free Ta-doped Lithium Garnets Li7-xLa3Zr2-xTaxO12 and the Degradation Mechanism in Humid Air

Fabrication and Characterization of Size-Controlled Single-Crystal-like PZT Nanofibers by Sol–gel Based Electrospinning

Hydrothernal Synthesis and Electric Properties of Fibrous Lead Zirconate Titanate

The Structures and Dielectric Properties of Ba0.80Sr0.20TiO3/Pb0.82La0.18TiO3 Composite Thick Films with Addition of PbO–B2O3 Glass

Investigation of heat treatment condition, ethylene glycol and deionized water effects on the phase structure of Ba0.6Sr0.4TiO3 nanoparticles produced by the sol-gel method