Abstract:Gated wires are widely used in Time Projection Chamber (TPC) to avoid ion back-flow (IBF) in the drift volume. The anode wires can provide stable gain at high voltage with a long lifetime. However, switching on and off the gated grid (GG) leads to a dead time and also limit the readout efficiency of the TPC. Gas Electron Multiplier (GEM) foil provides a possibility of continuous readout for TPC, which can suppress IBF efficiently while keeping stable gain. A prototype chamber including two layers of GEM foils and anode wires has been built to combine both advantages from GEM and anode wire. Using Garfield++ and the finite element analysis (FEA) method, simulations of the transmission processes of electrons and ions are performed and results on absorption ratio of ions, gain and IBF ratio are obtained. The optimized parameters from simulation are then applied to the prototype chamber to test the IBF and other performances. Both GEM foils are run at low voltage (255V), while most of the gain is provided by the anode wire. The measurement shows that the IBF ratio can be suppressed to ~0.58% with double-layer GEM foils (staggered) at an effective gain about 2500 with an energy resolution about 10%.

Study of A Multi-Wire Proportional Chamber with A Cathode Strip and Delay-Line Readout

Study and Application of Low Pressure Multi-Wire Proportional Chambers

Development Of Low Pressure Position Sensitive Multiwire Proportional Chamber

Experimental Research on A Boron-Coated Multi-Wire Proportional Chamber Neutron Detector

Study on Position Resolution of Low Pressure Multi-wire Proportional Chambers

The Proportional Ion Chamber and its Corresponding Circuit

Development of multichannel readout electronics system for MWPC of heavy ion radiotherapy

A Multiwire Proportional Chamber for Precision Studies of Neutron Beta Decay Angular Correlations

Study on the Position Resolution of Resistive Plate Chamber

Studies on ion back-flow of Time Projection Chamber based on GEM and anode wire grid

Design of the Front-End Electronics for Parallel Plate Ion Chamber

Micro-cathode Strip Chamber

Cosmic Muon Detector Using Proportional Chambers

Development of a Low Power and High Integration Readout ASIC for Time Projection Chambers in 65 Nm CMOS

A New Multi-Strip Ionization Chamber Used As Online Beam Monitor for Heavy Ion Therapy

Time resolution and characteristic study of MWPC detectors with different Argon based gas

Development of a multiwire proportional chamber with good tolerance to burst hits

Performance Testing of a Long-Strip Two-End Readout Multi-Gap Resistive Plate Chamber

A Front-End Electronics Module for Multi-gap Resistive Plate Chambers

A Position-Sensitive Micro-Channel Plate Detector with A Parallel-Strip Resistive Anode and Integrated Charge-Sensitive Amplifiers

Design and Experimental Study of a Two-Dimensional Position Sensitive X-ray Detector