Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Development of a Straw Tube Chamber with Pickup-Pad Readout

Study of A Multi-Wire Proportional Chamber with A Cathode Strip and Delay-Line Readout

Development of high granulated straw chambers of large sizes

A Straw Drift Chamber Spectrometer for Studies of Rare Kaon Decays

Construction and operation of a Double Phase LAr Large Electron Multiplier Time Projection Chamber

Design and Prototype Test of a High-Sensitivity Reentrant-Cavity Based Schottky Pickup.

A Panel Prototype for the Mu2e Straw Tube Tracker at Fermilab

Development of a portable gas-filled ionization chamber

Design and Performance of SiPM-based Readout of PbF2 Crystals for High-Rate, Precision Timing Applications

First operation of a double phase LAr Large Electron Multiplier Time Projection Chamber with a two-dimensional projective readout anode

Long-term operation of a double phase LAr LEM Time Projection Chamber with a simplified anode and extraction-grid design

A Tetramethylsilane TPC with Cherenkov Light Readout and 3D Reconstruction

Longitudinal tension and mechanical stability of a pressurized straw tube

Development and performance evaluation of a multi-layer boron-lined detector for the CPHS-SANS instrument

Performance of small-diameter muon drift tube chambers with new fast readout ASIC at high background rates

Production of Long-Strip Multi-Gap Resistive Plate Chamber Module for the Star-Mtd System

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Development Of Low Pressure Position Sensitive Multiwire Proportional Chamber

Measurement of the Rate Capability of Resistive Plate Chambers

Development of Hybrid Resistive Plate Chambers

Performance of Pad Front-End Board for Small-Strip Thin Gap Chamber with Cosmic Ray Muons