Abstract:The sintering temperature of piezoelectric ceramics plays a pivotal role in their cost and efficacy within the realm of multilayer actuator applications. While being conducive to piezoelectric capabilities of ceramics, the increase in sintering temperature entails higher fabrication costs. In contrast, a lower sintering temperature can reduce costs, but the performance of the actuator may be compromised. To address these issues, the Li-Sc co-doped 0.46PNN-0.23PIN-0.31PT ceramics were produced in the present work. At a relatively low sintering temperature (950 °C), the synergy of multiple ferroelectric phases and defect polarization could be achieved, thereby augmenting the electromechanical properties of the material. At an optimal doping ratio of 0.6 mol% for both Li and Sc, the ceramics demonstrated superior performance metrics, including d33 = 1000 pC/N, d33* = 1050 pm/V, kp = 0.53, and εr = 8001. Applying the Rietveld refinement and Rayleigh analysis, it was established that the incorporation of Li is essential in the formation of a rhombohedral phase-dominated morphotropic phase boundary (MPB), which decreases polarization anisotropy amidst the coexisting phases, facilitating polarization rotation and significantly enhancing the piezoelectric properties of ceramics. The nanodomains within the material were detected through SS-PFM and PFM testing. Notably, Sc3+-induced defects disrupted the extended ferroelectric domains, fostering the emergence of nanodomains with higher activity, which in turn enabled to markedly improve the electromechanical performance of the ceramics even at the lower sintering temperature. This investigation not only provides a viable strategy for curtailing the manufacturing costs of multilayer actuators but also opens up new prospects for the low-temperature fabrication of piezoelectric materials and their applications.

Low Temperature Sintering and Properties of Piezoelectric Ceramics PSNT-Mn with LiBiO2 Addition

Effect of MnCO3 on the Electrical Properties of PZT-based Piezoceramics Sintered at Low Temperature

Facile Preparation and Performance of Novel High-Tc Xbi(ni1/2ti1/2)o3-(1-x)pb(zr1/2ti1/2)o3 Piezoceramics

Low temperature sintering of Li2CO3 added Pb(Ni1/3Nb2/3)-Pb(Zr,Ti)O3 ceramics with high piezoelectric properties

Enhancing Electrical Properties of High-Curie Temperature Piezoelectric Ceramics BNT-PZT and Their Mechanism

Low‐temperature sintered 0.5Pb(Ni1/3Nb2/3)O3–0.16PbZrO3–0.34PbTiO3 piezoelectric textured ceramics by Li2CO3 addition

Effects of LiBiO2 addition on the microstructure and piezoelectric properties of CuO‐doped PNN–PZT ceramics

Low-temperature Sintered (Na1/2bi1/2)tio3-Based Incipient Piezoceramics for Co-Fired Multilayer Actuator Application

Effects of LiNbO3 Doping on the Microstructures and Electrical Properties of BiScO3–PbTiO3 Piezoelectric System

Low-Temperature Sintering of Lead Magnesium Nickel Niobate Zirconate Titanate (Pmn-Pnn-pzt) Piezoelectric Ceramic, with High Performances

Competition of Li+ and Cu2+ ions dopant in BiAlO3–Pb(Zr,Ti)O3 piezoelectric ceramics in low temperature sintering processes

Ultra-high piezoelectric and dielectric properties of low-temperature-sintered lead hafnium titanate-lead niobium nickelate ceramics

BiScO3-modified (k0.475na0.475li0.05)(nb0.95sb0.05)o3 Lead-Free Piezoelectric Ceramics

Low temperature sintering and enhanced piezoelectricity of lead-free (Na 0.52 K 0.4425 Li 0.0375)(Nb 0.86 Ta 0.06 Sb 0.08) O 3 ceramics prepared from nano-powders

Effects of (Li0.5Sm0.5)/W co-substitution and sintering temperature on the structure and electrical properties of ultrahigh Curie temperature piezoceramics, Ca0.92(Li0.5Sm0.5)0.08Bi2Nb2-W O9

Conductive mechanism and the enhancement high-power electrical properties of Mn-modified Bi(Sc3/4In1/4)O3–PbTiO3–Pb(Mg1/3Nb2/3)O3 high temperature piezoelectric ceramics

Piezoelectric Property Amplification in 0.46PNN-0.23PIN-0.31PT Ceramics Via Optimized Low-Temperature Sintering and Defect Chemistry

Low‐Temperature Sintering of Li‐Modified (K, Na)NbO3 Lead‐Free Ceramics: Sintering Behavior, Microstructure, and Electrical Properties

Low‐temperature sintering and enhanced piezoelectric properties of random and textured PIN–PMN–PT ceramics with Li2CO3

Excellent Electrostrictive Properties of Low Temperature Sintered Pzt Ceramics with High Concentration Libio2 Sintering Aid

Structure and dielectric/piezoelectric properties of LiNbO 3 -doped BiScO 3 –PbTiO 3 ceramics with morphotropic phase boundary composition