Low-temperature Sintered (Na1/2bi1/2)tio3-Based Incipient Piezoceramics for Co-Fired Multilayer Actuator Application

Pengyuan Fan,Yangyang Zhang,Shan-Tao Zhang,Bing Xie,Yiwei Zhu,Mohsin Ali Marwat,Weigang Ma,Kai Liu,Liang Shu,Haibo Zhang
DOI: https://doi.org/10.1016/j.jmat.2019.01.004
IF: 8.589
2019-01-01
Journal of Materiomics
Abstract:Low-temperature sintered (Na1/2Bi1/2)(0.935)Ba0.065Ti0.975(Fe1/2Nb1/2)(0.02)O-5(3) (NBT-BT-0.025FN) lead free incipient piezoceramics were investigated using high-purity Li2CO3 as sintering aids. With the <= 0.5 wt % Li2CO3 addition, the introduced Li+ cations precede to enter the A-sites of the perovskite lattice to compensate for the A-site deficiencies. Once the addition exceeds 0.5 wt%, the excess Li+ cations will occupy B-sites and give rise to the generation of oxygen vacancies, which accelerate the mass transport and thus lower the sintering temperature effectively from 1100 degrees C down to 925 degrees C. It was also found that a small amount of Li+ addition has little effect on the phase structure and electromechanical properties of the system, but overweight seriously disturbs these characteristics because of the large lattice distortion. The sintered NBT-BT-0.025FN incipient piezoceramics with 1.25 wt% Li2CO3 addition at 925 degrees C provides a large strain of 0.33% and a corresponding large signal piezoelectric coefficient d(3)(3)* of 550 pm/V at 60 kV/cm, indicating this system is a very promising candidate for lead-free co-fired multilayer actuator application. (C) 2019 The Chinese Ceramic Society. Production and hosting by Elsevier B.V.
What problem does this paper attempt to address?