The electrical properties of low-temperature sintered 0.07Pb(Sb1/2Nb1/2)O3-0.93Pb(Zr Ti1−)O3 multilayer piezoceramic actuator

Jian Chen,Zong-Zheng Du,Yu-Ting Yang,Hong Hu
DOI: https://doi.org/10.1016/j.ceramint.2021.02.081
IF: 5.532
2021-06-01
Ceramics International
Abstract:0.07Pb(Sb1/2Nb1/2)O3-0.93Pb(Zr x Ti1−x )O3 (PSbN-PZT) piezoceramics were fabricated at a low firing temperature of 920 °C using the LiBiO2, CuO and ZnO (LBCZ) sintering aids. The material samples exhibited excellent properties, including a converse piezoelectric coefficient d 33* of ~558 pm/V, a relative dielectric permittivity ε T 33/ε 0 of ~1725, a planar coupling factor k p of ~0.6 and a high Curie temperature T c of ~308 °C, thus demonstrating the material suitability for use as a low-cost multilayer actuator. PSbN-PZT piezoceramic multilayer actuators with Ag/Pd internal electrodes were fabricated by tape casting method cofired at 920 °C. A large displacement of 1.45 μm was achieved in a single PSbN-PZT multilayer actuator (thickness = 2.0 mm) at the driving voltage of 125 V, while the displacement decreased ~27% under the mechanical stress of ~32 MPa. Good temperature stability was also exhibited in PSbN-PZT multilayer actuator, which was better than that of commercial PZT-5H ceramic. These results indicated that low-temperature fired PSbN-PZT multilayer actuator is a promising candidate device for commercial piezoactuator applications.
materials science, ceramics
What problem does this paper attempt to address?