Abstract:This paper reports the micromachining techniques for fabricating edge-suspended RF/microwave passive components, which are proposed to deliver enhanced performance without sacrificing their mechanical strength and reliability. The fabrication incorporates ICP-DRIE dry etching and TMAH anisotropic etching techniques, which are both CMOS compatible. The edge-suspended structures were realized by a TMAH solution consisting of 5 wt% TMAH, 1.6 wt% Si and 0.5 wt% (NH4)(2)S2O8. This solution offers effective etching of silicon along the {100} and {110} planes, while having negligible etching on aluminum and {111} planes. The layout requirement for achieving edge-suspended passive components is also outlined on the basis of the analysis of the anisotropic etching along different crystal orientations. Using the techniques described here, high performance spiral inductors and coplanar waveguides (CPW) with significantly reduced loss are demonstrated. For a three-tum 4.5 nH inductor, a 70% increase (from 6.8 to 11.7) in maximum Q-factor and a 57% increase (from 9.1 GHz to 14.3 GHz) in self-resonance frequency are obtained with an 11 mum suspended edge in 25 mum wide lines compared to the conventional inductors without being micromachined. A 50 Omega edge-suspended CPW exhibits a reduction in insertion loss, from 2.4 dB mm(-1) in a conventional CPW to 0.4 dB mm(-1) at 39 GHz.

A Surface Micromachining Process for Suspended RF-MEMS Applications Using Porous Silicon

Fabrication Planar Coil on Oxide Membrane Hollowed with Porous Silicon As Sacrificial Layer

The Technology of Using Porous Silicon As a Sacrificial Layer in MEMS

A molded surface-micromachining and bulk etching release (MOSBE) fabrication platform on (1 1 1) Si for MOEMS

CMOS-compatible micromachining techniques for fabricating high-performance edge-suspended RF/microwave passive components on silicon substrates

Experimental Investigations Of Porous Silicon Sacrificial Layer Techniques On Mems

Large-scale Fabrication, 3D Tomography, and Lithium-Ion Battery Application of Porous Silicon.

AFM Tip-Based Fabrication of Silicon Nanostructures with Reduced Subsurface Amorphous Layers

A New Release Process for Polysilicon Surface Micromachining Using Sacrificial Polysilicon Anchor and Photolithography after Sacrificial Etching

Development of an SU-8 MEMS process with two metal electrodes using amorphous silicon as a sacrificial material

A new process for releasing micromechanical structures in surface micromachining with polysilicon support and LPCVD Si3N4 embedded mask

A Surface Micromachining Process Utilizing Dual Metal Sacrificial Layer for Fabrication of RF MEMS Switch

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Patterned Microstructure Array Fabrication By Using A Novel Standing Surface Acoustic Wave Device

Study on Compatible CMOS-MEMS Process with Surface Micromachining for the Application of Monolithic Integration

The key technologies in silicon based microwave and RF MEMS device fabrication

Electroless Copper Plating on Silicon Surface for Mems

Dual structural polysilicon BiFET-compatible surface micromachining module

Design of Μpemfc Fabricated with Porous Silicon

A New Release Process in Surface Micromachining-Double Mask Technology