Abstract:Sintering behaviour of ashes from combustion of coal and biomass blends was experimentally investigated with a focus on the effect of ash preparation method. Blends of a Chinese anthracite, Jincheng coal, and two biomass materials, a wheat straw and a pine sawdust, respectively, were subjected to three different ash preparation procedures, namely, a low temperature oxygen plasma ashing device operating at ca 150 degrees C, combustion in a Muffle furnace at 815 degrees C and in a drop tube furnace at 1500 degrees C. The resulting ash samples were then subjected to the sintering temperature measurement using a pressure-drop sintering device, morphological and mineralogical characterisation using scanning electron microscope (SEM) fitted with X-ray energy dispersive spectroscopy (EDS) and X-ray diffractometry analyser (XRD), respectively. For the same coal and biomass blends but different ash preparation methods, the sintering temperatures were always the lowest for the ash samples from the plasma ashing device and the highest from drop tube furnace. SEM imaging showed that the texture of ash samples from the plasma ashing device was irregular, loose and more fibrous, indicating little interactions among the different mineral and inorganic constituents in the individual fuels. The muffle furnace and drop tube furnace ashes were denser and more uniform in shape as the mineral matter and inorganics became fused together. In addition, the drop tube furnace ashes were mostly in spherical-shape, indicating ash melting had occurred during combustion. The XRD analysis revealed that different minerals were present in the ash samples due to different ash preparation temperatures, with high temperature minerals present in the drop tube furnace ash. Biomass addition in the blends lowered the sintering temperature of corresponding ash; the higher the proportion of biomass in the blend, the lower the ash sintering temperature regardless the ashing method. At the same biomass addition ratio, the ash sintering temperature of the blend with the wheat straw addition was lower than that with the pine sawdust addition, because the wheat straw had a higher K and Cl content but lower Ca than the pine sawdust. The EDS and XRD analyses confirmed that the ashes of coal/wheat straw blends contained more K-bearing minerals, while the ashes of the coal/pine sawdust contained more Ca and K-bearing minerals. Both Ca and K-bearing minerals reacted with other minerals in the ash to form low temperature eutectics, leading to the reduction of sintering temperatures of the coal and biomass blends. However, the melting points of the K-containing minerals are higher than the Ca-containing minerals, therefore, the sintering temperatures of ash with the wheat straw addition were lower than those with the pine sawdust addition. (C) 2016 Elsevier Ltd. All rights reserved.

Effect of Coal-water Slurry Reburning on Ash Deposition in Boiler

Effect of Coal Reburning and Injected Calcium on Fouling and Slagging Characteristics in Shenhua Coal Combustion

Research on the effects of the fly ash reburning on element migration and ash deposition characteristics of high-alkali coal in a full-scale slag-tapping boiler

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Investigation of Ash Deposition Characteristics in Full-Scale Circulating Fluidized Bed Boiler Burning Zhundong Coal

Research on the Dynamic Characteristic of Ash Deposition in Boilers Burning Coal and Coal Water Slurry

Influence of Coal Water Slurry Reburning on NOx Reduction

EXPERIMENTAL STUDY OF ASH DEPOSIT DURING CO-FIRING SAWDUST AND COAL

The Mineralogy Analysis Of Ash Deposition In Refractory Zones In A W-Flame Boiler

Ash Deposition of Zhundong Coal in a 350 MW Pulverized Coal Furnace: Influence of Sulfation

Mineral transformation during rapid heating and cooling of Zhundong coal ash

Migration and Deposition Behaviors of Main Mineral Elements in Combustion of Coal Black Liquor Slurry

Analysis on Deposition Mechanism of Ash with High Ash Fusion Temperatures on the Heat-insulation Layer in Boiler

Experimental Study on the Effects of Reheat Temperatures on the Ammonium Bisulfate and Ash Blend Deposition

Effect of Ash Preparation Method on the Sintering Characteristics of Ashes from Combustion of Coal and Biomass Blends

Microanalysis of solid residues from coal slurry fired furnace

Fly Ash Reburn To Enhance The Combustion Efficiency Of Cfb Boiler Burning Fujian Anthracite

Influence of Coal Water Slurry Volatile Reburning on NO Reduction

Influence of Ash Characteristics on Ash Deposition in Coal Fired Boiler

Comparative Experimental Study of Ash Formation Behaviors During the Fixed-Bed Gasification of Coal Water Slurry and Dry Pulverized Coal Prepared from Shenmu Coal

Effect of Chlorine, Sulfur, Moisture and Ash Content on the Partitioning of As, Cr, Cu, Mn, Ni and Pb During Bituminous Coal and Pickling Sludge Co-Combustion