Abstract:Phase field method was used to simulate the effect of grains orientation angle θ11 and azimuth θA of non-preferentially growing dendrites on the secondary dendrites of preferentially growing dendrites. In the simulation process, two single-factor influence experiments were designed for columnar crystal structures. The simulation results showed that, when θ11 < 45° and θA < 45°, as θ11 was enlarged, the growth direction of the secondary dendrites on the preferentially growing dendrites at the converging grain boundary (GB) presented an increasing inclination to that of preferentially growing dendrites; with increasing θA, the growth direction of the secondary dendrites on the preferentially growing dendrites at the converging GB exhibited greater deflection, and the secondary dendrites grew with branches; the secondary dendrites on the preferentially growing dendrites at diverging GBs grew along a direction vertical to the growth direction of the preferentially growing dendrites. When θA = 45° and θ11 = 45°, the secondary dendrites grew in a direction vertical to the growth direction of preferentially growing dendrites. The morphologies of the dendrites obtained through simulation can also be found in metallographs of practical solidification experiments. This implies that the effect of a grain’s orientation angle and azimuth of non-preferentially growing dendrites on the secondary dendrites of preferentially growing dendrites does exist and frequently appears in the practical solidification process.

Effect of Melt Convection on Primary Dendrite Arm Spacing in Directionally Solidified Pb-26%Bi Hypo-Peritectic Alloys

Effect of Sample Diameter on Primary and Secondary Dendrite Arm Spacings During Directional Solidification of Pb-26wt.%Bi Hypo-Peritectic Alloy

Primary Dendrite Arm Spacing During Unidirectional Solidification of Pb–Bi Peritectic Alloys

Influence of Pb doping on superconductivity of α-BiPd and β-Bi2Pd alloys

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

Peritectic Transformation and Primary Α-Dendrite Dissolution in Directionally Solidified Pb–26%Bi Alloy

Primary Cellular/Dendritic Spacing Selection of Al-4.95% Zn Alloy under Near-Rapid Directional Solidification Condition

Primary Dendrite Distribution in Directionally Solidified Sn–36 At.% Ni Peritectic Alloy

Effect of an Axial High Magnetic Field on Sn Dendrite Morphology of Pb–Sn Alloys During Directional Solidification

Microstructure Formation at Low Velocity During Directional Solidification of Pb-Bi Peritectic Alloys

Influence of a Weak Static Magnetic Field on the Primary Dendrite Arm Spacing of a Directionally Solidified Ni-based Superalloy

Banding Structure Formation During Directional Solidification of Pb–Bi Peritectic Alloys

Thermal and Solute Diffusion During Dendrite Growth of Mg-5wt.%Zn Alloy

Response of primary dendrite distribution to deceleration growth conditions in a SnNi peritectic alloy

Effect of Medium-Density Direct Current on Dendrites of Directionally Solidified Pb–50Sn Alloy

Phase-field Simulation of Secondary Dendrite Growth in Directional Solidification of Binary Alloys

Secondary Dendrite Arm Migration Caused by Temperature Gradient Zone Melting in the Directionally Solidified Sn–40 At.% Mn Peritectic Alloy

Dendrite Coarsening in Directionally Solidified Sn–36 At.%ni Peritectic Alloy in the Presence of the Migration of Secondary Dendrite Arms

Experimental and simulation of primary dendrite spacing in directional solidification of Al-7Si-0.36Mg alloy

Influence of Directional Solidification Variables on Primary Dendrite Arm Spacing of Ni-based Superalloy DZ125

Primary cellular/dendritic spacing selection in rapidly solidified peritectic alloy