Abstract:The microstructure of peritectic alloys of important applications determines the final properties of them. The growth of peritectic β phase which greatly influences the structure of peritectic systems is divided into three different types: peritectic reaction at TP: L + α → β, then solid-state peritectic transformation α → β and direct precipitation L → β. In addition to transparent organic systems, peritectic transformation was always analyzed using interrupted directional solidification during which the sample is kept stationary after experiencing a distance of directional growth. Then, the growth of β phase through peritectic transformation is accompanied with the migration of the α/β interface towards α phase below TP. However, it is found in SnNi peritectic system (L + Ni3Sn2 → Ni3Sn4) that the migration rate of Ni3Sn2/Ni3Sn4 interface is much larger than that of peritectic transformation. Further examination shows that this interface migration can also be induced by the diffusion-controlled liquid migration initiating at the Ni3Sn2/Ni3Sn4 interface. Based on the model describing the liquid migration process, the migration of the Ni3Sn2/Ni3Sn4 interface through liquid migration is predicted, which matches well with the experimental measurement. This shows that the diffusion-controlled liquid migration is dominant during the growth of β phase. Thus, the application of interrupted directional solidification should be further examined.

Microstructure Evolution of Directionally Solidifi Ed Sn-16%Sb Hyperperitectic Alloy

Microstructure Formation During Unidirectionally Solidified Pb-Bi-Sn Tenary Quasi-Peritectic Alloy

Microstructure Formation at Low Velocity During Directional Solidification of Pb-Bi Peritectic Alloys

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

Research on Lamellar Structure and Micro-Hardness of Directionally Solidified Sn-58bi Eutectic Alloy

Peritectic Transformation and Primary Α-Dendrite Dissolution in Directionally Solidified Pb–26%Bi Alloy

Microstructure evolution and strengthening mechanism of directional solidification Ni40.5Co30Cr11Fe11Al6Ta1.5 high entropy alloy

Microstructure Evolution and Mechanical Properties of Sn0.7Cu0.7Bi Lead-Free Solders Produced by Directional Solidification

Investigation of Microstructure Evolution and Phase Selection of Peritectic Cuce Alloy During High-Temperature Gradient Directional Solidification

Banding Structure Formation During Directional Solidification of Pb–Bi Peritectic Alloys

Microstructure Formation in Pb-30wt.%Bi Peritectic Alloy

Phase and Microstructure Selection in Directional Solidification of Pb-Bi Peritectic Alloys

Microstructure and tensile properties of Sn-1Cu lead-free solder alloy produced by directional solidification

Liquid migration and peritectic transformation: Investigation on their contributions to growth of peritectic phase in interrupted directional solidification

Effect of Sample Diameter on Primary and Secondary Dendrite Arm Spacings During Directional Solidification of Pb-26wt.%Bi Hypo-Peritectic Alloy

Microstructure evolution and solidification behaviour of Nb–16Si–22Ti–2Cr–2Al–6Hf alloy processed by directional solidification

Study Progress in Phase-field Simulation of Directional Solidification Microstructure

Preparation and Microstructure Analysis of Continuous Unidirectional Solidification Cu–P–Sn Alloy

Dependence of microstructure and mechanical properties on solidification condition of directionally solidified Zn-55Al-1.6Si alloys

Solidification Microstructure Selection of the Peritectic Nd-Fe-B Alloys

Phase-Field Simulation of Directional Solidification Microstructure Evolution in A Binary Alloy