Abstract:Lead-bismuth (Pb-Bi) alloys, as a superconducting material, have been widely studied at their superconducting transition temperatures and the critical magnetic fields for different composition ratios. Most of experimental studies focused on the stable ε phase formed at high temperatures, but less on the Pb-Bi alloys grown at low temperatures. So far, the structural and superconducting properties of the low-temperature Pb-Bi phases are far from good understanding. Here, we report our investigation of structural and superconducting properties of a low-temperature phase of Pb-Bi alloy. The Pb-Bi alloy films with a nominal thickness of about 6 nm are prepared by co-depositing Bi and Pb on Bi(111)/Si(111)-(7 × 7) substrates at a low temperature of 100 K followed by annealing at a treatment of 200 K for 2 h. The structural and superconducting properties of the Pb-Bi alloy films are characterized in situ by using low-temperature scanning tunneling microscopy/spectroscopy (STM/STS). It is observed that the spatially separated phases of nearly pure Bi(111) domains and Pb1–xBix alloy domains are formed in the films, where these phases can be identified by their distinct differences in the atomic structure and the distributions of step heights in the atomically resolved STM images, as well as by their distinguished STS spectra. The Pb1–xBix alloy phase presents the structure of Pb(111), in which about x ≈ 0.1 Bi is substituted for Pb. The STS spectra show that the Pb1–xBix alloy phase is superconducting, with a transition temperature Tc = 7.77 K derived from the variable-temperature measurements. This transition temperature is higher than that in pure Pb film (6.0–6.5 K), which can be well explained by the Mattias rules, with considering the fact that the average number of valance electrons increases after Bi atoms with five valance-electrons have been substituted for Pb atoms with four valance-electrons. The analysis shows that the ratio \begin{document}$ 2\Delta (0)/{k_{\rm{B}}}{T_{\rm{C}}}$\end{document} is about 4.94 with the superconducting gap \begin{document}$ \varDelta (0) = 1.66$\end{document} meV at 0 K, indicating that the Pb1–xBix alloy is a strongly-coupled superconductor. The non-superconducting Bi(111) and the superconducting Pb1–xBix alloy domains form an in-plane superconductor-normal metal-superconductor (S-N-S) Josephson junction. The proximity effect in the Bi(111) domains is measured at different N-S junctions, which suggests that the lateral superconducting penetration length in Bi(111) might be affected by the area of the quasi-two-dimensional interface. The superconducting gap in the Bi(111) region with a narrow width of 23 nm in an S-N-S Josephson junction is found to be greatly enhanced due to the existence of multiple Andreev reflections. Since Bi can host potential topological properties, the lateral Bi(111)-Pb1–xBix heterostructures, because of the existing proximity effect, could have potential applications in exploring the novel topological and superconducting phenomena.

Microstructure Formation in Pb-30wt.%Bi Peritectic Alloy

Microstructure Formation During Unidirectionally Solidified Pb-Bi-Sn Tenary Quasi-Peritectic Alloy

Phase and Microstructure Selection in Directional Solidification of Pb-Bi Peritectic Alloys

Microstructure Formation at Low Velocity During Directional Solidification of Pb-Bi Peritectic Alloys

Banding Structure Formation During Directional Solidification of Pb–Bi Peritectic Alloys

Peritectic Transformation and Primary Α-Dendrite Dissolution in Directionally Solidified Pb–26%Bi Alloy

Primary Dendrite Arm Spacing During Unidirectional Solidification of Pb–Bi Peritectic Alloys

Microstructure Evolution and Mechanical Properties of Sn0.7Cu0.7Bi Lead-Free Solders Produced by Directional Solidification

Deformation mechanism of various Sn-xBi alloys under tensile tests

Microstructure Evolution of Directionally Solidifi Ed Sn-16%Sb Hyperperitectic Alloy

Effect of Sample Diameter on Primary and Secondary Dendrite Arm Spacings During Directional Solidification of Pb-26wt.%Bi Hypo-Peritectic Alloy

Effect of 1wt.%Bi addition on microstructure and mechanical property of Mg–3Al alloy by twin roll casting and hot rolling

Research on Lamellar Structure and Micro-Hardness of Directionally Solidified Sn-58bi Eutectic Alloy

Solidification Microstructure Selection of the Peritectic Nd-Fe-B Alloys

Coarsening of the Second Phase in Directionally Solidified Al-Bi Monotectic Alloys

Investigation of Microstructure Evolution and Phase Selection of Peritectic Cuce Alloy During High-Temperature Gradient Directional Solidification

Non-Equilibrium Crystallization of Monotectic Zn-25%Bi Alloy under 600 g

Characterization of Structure and Superconducting Properties of Low-Temperature Phase of Pb-Bi Alloy Films

Long-Term Microstructural Stability of Sn-40Bi and Sn-40Bi-10In Alloys

Effect of Melt Convection on Primary Dendrite Arm Spacing in Directionally Solidified Pb-26%Bi Hypo-Peritectic Alloys

Microstructural Evolution and Mechanical Properties of Sn‐58Bi Solder Alloys with Different Cooling