Abstract:When an insulating material is subjected to electron irradiation, it produces a secondary emission the yield of which varies from a few percent to very high values (up to 24 per incoming electron) depending on the material and the experimental conditions. If the secondary electron emission yield is less than one, a net negative charge remains trapped in the sample. In this case, the study of the electric charges trapping properties of the material becomes possible. This article describes how it is possible to use a secondary electron microscope (SEM) as a device to perform such a study. In Sec. II, the effect of a net negative trapped charge resulting (from the injection of typically 50 pC) on the imaging process of the SEM has been described. It has been shown that when the trapped charge is high enough, it acts as a mirror reflecting the incoming electron beam which is deflected somewhere in the vacuum chamber of the microscope. A global qualitative description of the image displayed on the screen is first presented. Then electron trajectories are quantitatively studied by using the Rutherford scattering cross section in the case of a point charge. When the charge is extended, a numeric simulation has been done in order to predict the validity range of the previous model. Once the trajectories have been calculated, the connection between the remarkable elements of the image and the quantity of trapped charges has been established. Moreover, this technique allows one to study the lateral dimension of the trapped charge zone and to measure the surface potential. In Sec. III, the discussion is first focused on some precautions to be taken concerning the sample preparation before the experiment is performed. It has been shown that surface defects due either to contamination layers or machining change the trapping properties of single-crystals ceramics such as MgO and Al2O3. A cleaning procedure is proposed that consists of annealing the sample at 1500 °C for 4 h in order to heal the crystalline defects and a heating at 400 °C in the vacuum chamber of the SEM to remove the contamination layers. Finally, the effect of the temperature on the trapping properties of pure and chromium doped sapphire has been studied in relation with the chromium concentration. It is shown that temperature behavior of trapping is in relation with the chromium concentration. In the pure sapphire trapping is activated below −16 °C, in 500 ppm rubis it is below −9.5 °C due to isolated chromium atoms, and in the 8000 ppm rubis the critical trapping temperature rises to 3.7 °C due to Cr3+ pairs. The interpretation of the role played by chromium on trapping is based on the experimental study of the fluorescence of chromium atoms and pairs as a function of concentration.

Charge Contrast Imaging of Nonconductive Samples in the High‐Vacuum Field Emission Scanning Electron Microscope

Charge Conversion Of Nearly Free And Impurity Bound Magneto-Trions Immersed In 2d Electron Or Hole Gas With Optically Tunable Concentration

Micrograph contrast in low-voltage SEM and cryo-SEM

Imaging Simulation of Charged Nanowires in TEM with Large Defocus Distance.

An enhanced visualization image acquisition method for samples with poor conductivity under a conventional scanning electron microscope

Amplitude Contrast Imaging in High-Resolution Transmission Electron Microscopy of Ferroelectric Superlattice Film

SEM imaging of insulating specimen through a transparent conducting veil of carbon nanotube

Direct Imaging of Lithium Ions Using Aberration-Corrected Annular-Bright-Field Scanning Transmission Electron Microscopy and Associated Contrast Mechanisms

Electron Imaging of Nanoscale Charge Distributions Induced by Femtosecond Light Pulses

Scanning Electron Microscopy Imaging of Single-Walled Carbon Nanotubes and Devices

Intermittent Contact Alternating Current Scanning Electrochemical Microscopy: A Method for Mapping Conductivities in Solid Li Ion Conducting Electrolyte Samples

Space charge measurement in a dielectric material after irradiation with a 30 kV electron beam: Application to single-crystals oxide trapping properties

Direct Imaging of Electron Orbitals with a Scanning Transmission Electron Microscope

Evaluating the performance of ionic liquid coatings for mitigation of spacecraft surface charges

Charge-carrier-concentration inhomogeneities in alkali-treated Cu(In,Ga)Se2 revealed by conductive atomic force microscopy tomography

Conditions required for high quality high magnification images in secondary electron-I scanning electron microscopy

Imaging Coherent Electron Flow

Direct Identification of Metallic and Semiconducting Single-Walled Carbon Nanotubes in Scanning Electron Microscopy.

Image Charge Effect on the Light Emission of Rutile TiO2 (110) Induced by a Scanning Tunneling Microscope

Charging Effect in Silicon Nanocrystals Observed by Electrostatic and Kelvin-probe Force Microscopy