Abstract:Carbon nanotube (CNT) film can be used as thin film electrodes and wearable electronic devices due to their excellent mechanical and electrical properties. The femtosecond laser has the characteristics of an ultra-short pulse duration and an ultra-high peak power, and it is one of the most suitable methods for film material processing. The ablation and patterning of CNT film are performed by a femtosecond laser with different parameters. An ablation threshold of 25 mJ/cm2 was obtained by investigating the effects of laser pulse energy and pulse number on ablation holes. Raman spectroscopy and scanning electron microscope (SEM) were used to characterize the performance of the pattern groove. The results show that the oligomer in the CNT film was removed by the laser ablation, resulting in an increase in Raman G band intensity. As the laser increased, the ablation of the CNTs was caused by the energy of photons interacting with laser-induced thermal elasticity when the pulse energy was increased enough to destroy the carbon–carbon bonds between different carbon atoms. Impurities and amorphous carbon were found at and near the cut edge while laser cutting at high energy, and considerable distortion and tensile was produced on the edge of the CNTs’ groove. Furthermore, appropriate cutting parameters were obtained without introducing defects and damage to the substrate, which provides a practical method applied to large-area patterning machining of CNT film.

Large area patterned arrays of aligned carbon nanotubes via laser trimming

Ablation and Patterning of Carbon Nanotube Film by Femtosecond Laser Irradiation

Efficient Fabrication of Carbon Nanotube Micro Tip Arrays by Tailoring Cross-Stacked Carbon Nanotube Sheets.

Aligned Single-Walled Carbon Nanotube Patterns with Nanoscale Width, Micron-Scale Length and Controllable Pitch

Electron emission from arrays of carbon nanotubes/fibres

The Fabrication of Vertically Aligned and Periodically Distributed Carbon Nanotube Bundles and Periodically Porous Carbon Nanotube Films Through a Combination of Laser Interference Ablation and Metal-Catalyzed Chemical Vapor Deposition.

Using Nanoscale Thermocapillary Flows to Create Arrays of Purely Semiconducting Single-Walled Carbon Nanotubes

Uniform Patterned Synthesis of Vertically-Aligned Carbon Nanotubes on Low-Stress Micromechanical Structures

Fabrication and electrical characteristics of carbon nanotube-based microcathodes for use in a parallel electron-beam lithography system

Preferential Growth of Carbon Nanotubes/Nanofibers Using Lithographically Patterned Catalysts

Controlled Removal of Individual Carbon Nanotubes from Vertically Aligned Arrays for Advanced Nanoelectrodes

Integrating Vertically Aligned Carbon Nanotubes on Micromechanical Structures

Visible Diffraction from Quasi-Crystalline Arrays of Carbon Nanotubes.

What Can Lasers Do in the Nano-Fabrication of Carbon Nanotube Based Devices?

Wafer Scale Synthesis of Dense Aligned Arrays of Single-Walled Carbon Nanotubes

Patterning and growth of carbon nanotubes on a highly structured 3D substrate surface

Controlled Growth Of Arrays Of Straight And Branched Carbon Nanotubes.

Efficient Fabrication of Vertical Carbon Nanotube Array Cold Cathode Using Laser Cutting

Laser-assisted simultaneous transfer and patterning of vertically aligned carbon nanotube arrays on polymer substrates for flexible devices

Fabrication of multi-level carbon nanotube arrays with adjustable patterns.

Rapid Growth of Well-Aligned Carbon Nanotube Arrays