Effect of initial condition on the quality of GaN film and AlGaN/GaN heterojunction grown on flat sapphire substrate with ex-situ sputtered AlN by MOCVD
Zhaole Su,Rui Kong,Xiaotao Hu,Yimeng Song,Zhen Deng,Yang Jiang,Yangfeng Li,Hong Chen
DOI: https://doi.org/10.1016/j.vacuum.2022.111063
IF: 4
2022-07-01
Vacuum
Abstract:The growth condition of initial medium (870 °C–920 °C) temperature (MT) layer is crucial to the quality of high temperature (HT) GaN layer and AlGaN/GaN heterojunction grown on flat sapphire substrate (FSS) with ex-situ sputtered AlN. The superior wetting of GaN and AlN makes the MT layer tend to directly two-dimensional (2D) growth mode at the initial stage. In this study, it was found that high pressure was effective in lowering Ga adatom diffusion and promoting early three-dimensional (3D) growth, which resulted in reducing (102) X-ray full-width-at-half-maximum as well as edge dislocation density significantly. The lowest X-ray rocking curve full-width-at-half-maximum of (002) and (102) were 35 arcsec and 220 arcsec respectively, which were comparable with GaN layer grown on patterned sapphire substrate (PSS). High quality AlGaN/GaN heterojunction was achieved with sheet electron density of 1.18×1013cm−2, Hall mobility of 1909 cm2/V⋅s and sheet resistance of 336 Ω/□. Controlled growth interruption was carried out to study the evolution mechanism of MT layer growth.
materials science, multidisciplinary,physics, applied