Abstract:Single-walled carbon nanotubes (SWNTs) have attracted much attention due to their unique structural, mechanical, chemical, and electrical properties. Catalytic chemical vapor deposition (CCVD) through decomposition of hydrocarbons is one of the most challenging synthesis methods to produce SWNTs in large scale. In this paper, high quality SWNTs prepared in a nano-agglomerated fluidized bed reactor (NAFBR) was reported. The reactor is a vertical quartz tube with the inner diameter of about 50 mm. Catalysts nanoparticles used for the production of SWNTs were prepared with Fe metal nanoparticles carried on the surface of MgO. About 150g catalysts powders were loaded on the gas distribution grid. The reaction temperature was controlled at not less than 1123 K. The carrier gas of argon was used to maintain turbulent fluidization of the catalysts powders in FBR. The hydrogen gas was used to reduce the catalysts and to synergize the growth of SWNTs with methane. The powder products were spherical agglomerates of SWNTs bundles tangling with the catalysts particles. By optimizing the process parameters of CCVD, the products of SWNTs with the diameter about 0.9 ∼ 1.8 nm were prepared, without any multi-walled carbon nanotubes (MWNTs) or amorphous carbon. The microstructure of SWNTs products were characterized by the methods of high resolution transmission electron microscopy (HRTEM), scanning electron microscopy (SEM), Raman spectra, etc. The NAFBR is a commercially viable (effective and continuous production at a low cost) process for the production of SWNTs.

Long Bundles of Aligned Carbon Nanofibers Obtained by Vertical Floating Catalyst Method

Large‐Scale Synthesis of Rings of Bundled Single‐Walled Carbon Nanotubes by Floating Chemical Vapor Deposition

Large-Scale and Selective Synthesis of Carbon Nanofiber Bundles, Curved Carbon Nanofibers and Helical Carbon Nanofibers.

Aligned Cnx Nanotubes By Pyrolysis Of Ferrocene/C-60 Under Nh3 Atmosphere

Single Walled 0.4 Nm Carbon Nanotube Bundles Prepared By Pyrolysis Of N-Hexane Catalyzed By Ferrocene

Formation of Close-Packed Multi-Wall Carbon Nanotube Bundles

Co-synthesis of Single-Walled Carbon Nanotubes and Carbon Fibers

Growth of well-crystallized segmented graphite nanofibers by catalytic chemical vapor deposition

Preparation of carbon nanofibers by the floating catalyst method

Synthesis of Single-Walled Carbon Nanotubes by the Vertical Floating Catalyst Method

Realizing Single-Crystalline Vertically-Oriented and High-Density Electrospun Nanofibril Bundles by Controlled Postcalcination

Floating Bimetallic Catalysts for Growing 30 cm‐Long Carbon Nanotube Arrays with High Yields and Uniformity

Production of novel amorphous carbon nanostructures from ferrocene in low-temperature solution

Fabrication of well-aligned carbon nanofiber array and its gaseous-phase adsorption behavior

Agglomerated CNTs Synthesized in a Fluidized Bed Reactor: Agglomerate Structure and Formation Mechanism

Conformation and Microstructure of Carbon Nanofibers Deposited on Foam Ni

Production of High Quality Single-Walled Carbon Nanotubes in a Nano-Agglomerated Fluidized Bed Reactor

Controllable and Large-Scale Synthesis of Carbon Nanofibers, Bamboo-Like Nanotubes, and Chains of Nanospheres over Fe/Sno2 and Their Microwave-Absorption Properties

Growth of Super Long Vertically Aligned Carbon Nanotube Arrays from Cyclohexane Via Floating Catalyst Method

Aligned array of N 2 -encapsulated multilevel branched carbon nanotubes

Carbon nanofibers prepared by a novel co-extrusion and melt-spinning of phenol formaldehyde-based core/sheath polymer blends