Microcalorimetric Studies of Surface Acid/Base Properties of Magnesium Iron Catalysts Prepared from Hydrotalcite-Type Precursors

Mai Tu,Jianyi Shen,Yi Chen
DOI: https://doi.org/10.1006/jssc.1996.7151
IF: 3.3
1997-01-01
Journal of Solid State Chemistry
Abstract:Magnesium–iron mixed oxides with Mg/Fe molar ratios 1,3, and 6 were prepared from hydrotalcite-type precursors. Microcalorimetric adsorption of NH3and CO2showed that the surface acidity and basicity of the mixed oxides after calcination at 673 K are similar despite the different Mg/Fe ratios. Increasing calcination temperature from 673 to 773 K significantly decreased the surface area of the 3 Mg/Fe oxide, but the densities of both the acid and base sites were not changed. Mössbauer spectroscopy revealed that the reduction of the 3 Mg/Fe oxide (Fe2O3/MgO) in H2at 673 K converted all Fe3+to Fe2+. The resulted FeO/MgO exhibited the same acidity as that of the Fe2O3/MgO, but the basicity of the FeO/MgO was greatly enhanced. Reduction at 773 K resulted in the formation of 76% Fe2+and 24% Fe0as detected by Mössbauer spectroscopy. The Fe/FeO/MgO sample formed exhibited very low heat for the adsorption of NH3(40 kJ/mol) indicating that all iron atoms on the surface are Fe0. However, a substantial basicity remained on the surface of this sample that may account for its high olefin selectivity compared with pure iron catalyst in the Fischer–Tropsch synthesis.
What problem does this paper attempt to address?