Abstract:In recent decades, the high catalytic activity of MgAl mixed oxides (MOs) and rehydrated hydrotalcites (HTCs) has made them very promising basic catalysts for various organic reactions. The synthesis procedure as well as the mechanism of the formation of HTC structure has been well described. Despite this, little has been published on how synthetic parameters affect the physico-chemical properties, rehydration ability and performance of the hydrotalcite-derived catalysts. Here, a series of catalysts with the same molar ratio Mg/Al = 3 varied by the co-precipitation conditions (pH value, temperature, ageing duration) were synthesized and used as precursors for the preparation of the MgAl MOs and rehydrated HTCs. The set of methods (AAS, XRD, SEM, N 2 -physisorption, TGA and CO 2 -TPD) was used to establish a relation between the synthetic parameters and the physico-chemical properties of the prepared materials. Their catalytic performance was monitored in aldol condensation of furfural and acetone as a model reaction. Preparations at different pH values and temperature resulted in the formation of HTC samples with crystallite size evaluated by XRD in the range of 70–230 Å ( d 003 ). Nevertheless, the crystallite size of the resulting MOs was similar in the range of 30–36 Å ( d 003 ). The rehydration of the MOs for 5–120 min produced high-crystalline reconstructed HTC with a crystalline size in the range of 82–111 Å ( d 003 ), i.e. the crystallite size of a large-size HTC precursor was not restored. Catalytic results revealed that the crystallite size of an as-prepared HTC precursor was a crucial parameter that affected the performance of both MOs and reconstructed HTCs in the condensation reaction. Furfural conversion over MOs and short-time rehydrated (5–10 min) materials in the reaction was strongly dependent on initial size of the as-prepared HTC crystallites. In contrast, the catalytic performance of the catalysts rehydrated for 120 min, was similar: furfural conversion was above 99% in all cases. Based on these results, the effect of the physico-chemical properties of the as-prepared HTCs on the catalytic performance of both MOs and reconstructed MgAl HTCs was established. A difference in the properties of the prepared samples was explained assuming the existence of extra-framework or partially framework Al-rich species that prevented the access of reactant molecules to catalytically active sites: the larger the crystallite size of the as-prepared precursor, the higher the excess of both structural defects and non-framework Al-rich species, and the lower the furfural conversion over these catalysts. Nevertheless, long rehydration time favored the involvement of the Al-rich species in the recrystallization of HTC structure as evidenced by SEM. As a consequence, furfural conversion increased over these catalysts. These results provide a new insight into the influence of synthetic parameters on the properties of MOs and rehydrated HTCs: the crystallite size of the as-prepared precursors determines the performance of the produced catalysts in aldol condensation by affecting the rehydration ability of the derived MOs.

Synthesis, Characterization And Isopropanol Catalytic Reaction Of Mg/Al,Co/Al And Co/Mg/Al Mixed Oxides From Hydrotalcite And Hydrotalcite-Like Precursors

Ce/MgAl mixed oxides derived from hydrotalcite LDH precursors as highly efficient catalysts for ketonization of carboxylic acid

Preparation of PtCl62-Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Synthesis Of Mg-Zn-Al Hydrotalcites-Like And Catalytic Activities Of Their Composite Oxides

Preparation of PtCl_6~(2-) Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Influence of Acid-Base Properties of ZnMgAl-mixed Oxides for the Synthesis of 1-Methoxy-2-propanol

Effects of Pore Structure on Methanol Selectivity in Carbon Monoxide Hydrogenation

Preparation and Characterization of Fe/MgO Catalysts Obtained from Hydrotalcite-Like Compounds

An atom-economic reaction for synthesis of 1-phenoxy-2-propanol over Al2O3/MgO

The Catalytic Character of SrO Ⅱ.Study of the Decomposition of Isopropanol over MgO and SrO Catalysts

Production of Oxygen-containing Compounds Catalytic from Depolymerization of Calcium Lignosulphonate by Submicron-scale MgAl Solid Base

STUDIES OF OXIDATIVE DEHYDROGENATION OF PROPANE WITH CARBON DIOXIDE TO PROPENE Preparation, Surface Microcalorimetric Adsorption and Catalytic Activity of Cr-Mg-Al-O Mixed Oxide Catalysts

The influence of Mg/Al molar ratio on the performance of CuMgAl-x catalysts for CO2 hydrogenation to methanol

Effects of Cobalt Promoter and Reduction Temperature on the Surface Species and Syngas Adsorption of K–Co–Mo/C Catalyst for Mixed Alcohols Synthesis

Preparation of Highly Dispersed Cu Catalysts from Hydrotalcite Precursor for the Dehydrogenation of 1,4-Butanediol

Effect of coprecipitation method on Mg–Al hydrotalcite properties: application in the synthesis of diethylene glycol di-(methyl carbonate)

On the influence of synthetic parameters on the properties and aldol condensation performance of the MgAl mixed oxides and rehydrated hydrotalcites

Synthesis of higher alcohols by CO hydrogenation over catalysts derived from LaCo1-xMnxO3 perovskites: Effect of the partial substitution of Co by Mn

Characterization Of Tio2-Zro2 And Isopropanol Catalytic Conversion

Constructing the active pairs of Co0-Co2+ via surface solid reaction on TiO2 with the additives of La and Al for higher alcohols synthesis

Catalytic Properties and Structure of the K-Co-Mo Catalysts Prepared by Sol-Gel Method for Mixed Alcohol Synthesis — Effect of K Content