Abstract:Fischer–Tropsch synthesis (FTS) is a heterogeneously catalyzed polymerization reaction in which H2 and CO reactant molecules are dissociated on the catalyst surface and are associated with forming a wide range of linear and branched hydrocarbon chains. Catalyst development plays a key role in FTS technology. As the world shifts towards renewable and sustainable energy sources, converting syngas into hydrocarbons using Fischer–Tropsch synthesis (FTS) catalysts is crucial. In this work, a series of copper‐modified iron‐based catalysts with cerium and strontium promoters supported on γ‐Alumina as follows were prepared using a wet‐impregnation method: FCA (18Fe/4Cu/γ‐Al2O3), FCCA (18Fe/4Cu/2Ce/γ‐Al2O3), FCSA (18Fe/4Cu/2Sr/γ‐Al2O3), and FCCSA (18Fe/4Cu/1Ce/1Sr/γ‐Al2O3). The phase, structure, and morphology of the catalysts were characterized using X‐ray diffraction (XRD), Brunauer–Emmett–Teller (BET) specific surface area analysis, field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), inductively coupled plasma–atomic emission spectrometry (ICP‐AES), hydrogen temperature‐programmed reduction (H2‐TPR), and hydrogen temperature‐programmed desorption (H2‐TPD). The impacts of Ce and Sr, individually and in combination, on the structure, adsorption, reduction, and catalytic performance of the catalysts were evaluated in a fixed bed reactor at 300°C, 2.0‐MPa pressure, a time of stream of 168 h, and an H2/CO ratio of 1. The CO conversion and product selectivity were calculated using gas chromatography results, highlighting the synergistic effect of Ce and Sr promoters on hydrocarbon product distribution. The doubly promoted FCCSA catalyst exhibited a high CO conversion rate of 77.65%, CO2 selectivity of 43.5%, C2‐C4 selectivity of 55.89%, C5+ selectivity of 85.62.0%, and a yield of 43.19%, surpassing FCA, FCCA, and FCSA catalysts. Similar characteristics, CO conversion, and product selectivity were achieved for FCCSA during long‐term 336‐h FTS runs, indicating stability.

Effect of alkaline-earth metals (Mg, Ca, Sr, and Ba) on precipitated iron-based catalysts for high-temperature Fischer-Tropsch synthesis of light olefins

The Effect of Hydrophobically Modified Iron Catalysts with Hexadecyltrimethoxysilane on Fischer‐Tropsch Synthesis

Effect of Zr promoter on precipitated iron-based catalysts for high-temperature Fischer-Tropsch synthesis of light olefins

The Effect of Na Promoter on Fe-Based Catalyst for CO2 Hydrogenation to Alkenes

Effect of Na Addition on Iron-Based Catalyst for Fischer-Tropsch Synthesis

Effect of Preparation Conditions on Precipitated Iron-Based Catalysts for High-Temperature Fischer–Tropsch Synthesis of Light Olefins

Effects of alkaline-earth metals on CoMn-based catalysts for the Fischer–Tropsch synthesis to olefins

Effect of Rare-Earth Promoters on Precipitated Iron-Based Catalysts for Fischer–Tropsch Synthesis

Surface Chemical Effects on Fischer–Tropsch Iron Oxide Catalysts Caused by Alkali Ion (Li, Na, K, Cs) Doping

Synergistic Effects of Cerium and Strontium Promoters on Copper‐Modified Iron‐Based Fischer–Tropsch Synthesis Catalysts

Γ-Fe2o3 As the Precursor of Iron Based Catalyst Prepared by Solid-State Reaction at Room Temperature for Fischer-Tropsch to Olefins

Effect of different alkaline earth metals on the adsorption and catalytic behavior of cobalt Fischer–Tropsch synthesis

The effect of surface acidic and basic properties of highly loaded Co catalysts on the Fischer–Tropsch synthesis

Effects of Al, Si, Ti, Zr Promoters on Catalytic Performance of Iron-Based Fischer–Tropsch Synthesis Catalysts

Preparation and Characterization of Fe/MgO Catalysts Obtained from Hydrotalcite-Like Compounds

Selective production of light α-olefins and long-chain α-olefins from CO2/H2 and CO/H2 over iron-based catalysts: Effects of Na2S and H2O

Comparison of Preparation Methods of Iron-Based Catalysts for Enhancing Fischer-Tropsch Synthesis Performance

Syngas-derived Olefins over Iron-Based Catalysts: Effects of Basic Properties of MgO Nanocrystals

Effect of copper on highly effective Fe-Mn based catalysts during production of light olefins via Fischer-Tropsch process with low CO2 emission

Eco-friendly solid-state synthesis of Na-promoted Mn-Fe/ZrO 2 catalyst for Fischer-Tropsch synthesis

Enhancing the Light Olefin Selectivity of an Iron-Based Fischer-Tropsch Synthesis Catalyst by Modification with CTAB