Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

Process Variation Compensation of a 2.4GHz LNA in 0.18um CMOS Using Digitally Switchable Capacitance.

0.9–10GHz low noise amplifier with capacitive cross coupling

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop

Design of a Fully Integrated Switchable Transistor CMOS LNA for 2.1 / 2.4 GHz Application

A 3.4 Db Nf K-Band Lna with A Tapped Capacitor Matching Network in 65 Nm Cmos Technology

A Compensating Technique for RF Performance Degradation of Low Noise Amplifier in Nanoscale CMOS Process

A 140 GHz, 4 Db Noise-Figure Low-Noise Amplifier Design with the Compensation of Parasitic Capacitance CGS

A Switchable Dual-Band LNA with Simultaneous Noise and Input Impedance Matching for GSM/TD-SCDMA Applications

A dual band CMOS two-stage variable gain low noise amplifier

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 0.9/1.8/2.4Ghz-Reconfigurable LNA with Inductor and Capacitor Tuning for IoT Application in 65nm CMOS

A 22.9–38.2-Ghz Dual-Path Noise-Canceling LNA with 2.65–4.62-Db NF in 28-Nm CMOS

Temperature Compensation Design For A 2.4ghz Cmos Low Noise Amplifier

A CMOS Dual-Feedback Reconfigurable Low Noise Amplifier with Improved Stability and Reduced Noise.