Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A Switchable Dual-Band LNA with Simultaneous Noise and Input Impedance Matching for GSM/TD-SCDMA Applications

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A dual-band 2.1GHz/5.2GHz LNA for reconfigurable radio

A dual band CMOS two-stage variable gain low noise amplifier

Dual-Band CMOS Low-Noise Amplifier

Design of C-band low noise amplifier with switch

Design of a Fully Integrated Switchable Transistor CMOS LNA for 2.1 / 2.4 GHz Application

Inductorless CMOS Low Noise Amplifier for Multiband Application in 0.1–1.2 GHz

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

A 0.9/1.8/2.4Ghz-Reconfigurable LNA with Inductor and Capacitor Tuning for IoT Application in 65nm CMOS

Co-Design of a Low-Noise Amplifier and SPDT SW for Band 42 T/R Modules with Low NF, High Gain, and 50-ohm Matching in Bulk CMOS Technology

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A 28/39 GHz Tri-Mode Frequency-Reconfigurable LNA for Multiband 5G Communications

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Re-use in 28-Nm CMOS Technology

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

CMOS Wide Band Programmable Gain Low Noise Amplifier

A 23-30 GHz LNA with Noise-Cancelling in 28nm CMOS