Abstract:The vast deployment of 5G communication system calls for low-cost, easy-to-integrate RF Front End Integrated Circuits (RFFE ICs) design. For better system performance, specific processes, such as SOI/GaN/GaAs, are widely used for RFFE receiver IC design. However, these specific processes are costly and hard to integrate with baseband ICs which are typically fabricated in bulk CMOS process. To overcome the high cost and integration challenges, this paper designed a Band 42 low-noise power amplifier (LNA) together with a single-pole double-throw switch (SDPT SW) in a 55nm bulk CMOS process. For the LNA, we integrated source degeneration inductance and gate-source capacitance feedback, which provides significant stability, matching and noise figure benefits. For LNA and SW co-optimization, we reduced the overall noise by reusing the input matching network. The B42 receiver's minimum return loss(SW included) is better than -20dB, gain higher than 28dB, and the noise figure is better than 2.4dB; the switch's off-state isolation is better than 30dB. To our knowledge, this B42 receiver RFFE design is the best combination of performance and cost in the Bulk CMOS process. This work demonstrated the possibility of fully integrating RFFE circuits in low cost bulk CMOS process with good performance.

Design of C-band low noise amplifier with switch

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Switchable Dual-Band LNA with Simultaneous Noise and Input Impedance Matching for GSM/TD-SCDMA Applications

Design of K-band Compact Wideband Low Noise Amplifier

A High Linearity Wideband LNA with an Excellent Gain Flatness for S-band Application

4-20 GHz Low Noise Amplifier MMIC with On-Chip Switchable Gate Biasing Circuit

A 0.18 μm CMOS 3–5GHz switched gain low noise amplifier for UWB system

Design of a 2–18 GHz low noise amplifier MMIC with current reused topology

Design of a Fully Integrated Switchable Transistor CMOS LNA for 2.1 / 2.4 GHz Application

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A dual band CMOS two-stage variable gain low noise amplifier

A 18–44 GHz Low Noise Amplifier with Input Matching and Bandwidth Extension Techniques

Design of Ka band Low Noise Amplifier Based on 65nm CMOS Technology

Design and Implementation of an X-band High Performance Low Noise Amplifier

Analysis and Design of a 2-40.5 GHz Low Noise Amplifier With Multiple Bandwidth Expansion Techniques

Design of the 0.2-3Ghz Ultrawide-band Low Noise Amplifier

Co-Design of a Low-Noise Amplifier and SPDT SW for Band 42 T/R Modules with Low NF, High Gain, and 50-ohm Matching in Bulk CMOS Technology