Abstract:The group-Ⅲ nitrides and their related ternary alloys have been becoming the most attractive material for light emitting diodes (LEDs) and laser diodes (LDs) in the UV and blue spectral range. However, the origins of the yellow luminescence (YL), which is commonly observed in almost undoped and n-type GaN, remain unclear. The nature and the role of initial nitridation of sapphire surface and the generation of threading dislocation (TD) are ambiguous too. It is a possible way to resolve the above problems by studying the microstructures and optical properties combining the growth conditions. In this work, two kinds of GaN films were grown by MOCVD under different initial nitridation time (180 seconds for Sample A, and 90s for Sample B). The growth temperature is about 950℃. The cross-sectional transmission electron microscope (TEM) is performed near the GaN/sapphire interface. Corresponding the growth processes, there are three zones in the GaN layer: buffer layer, zone and sound zone. There are haystack-like domains in the faulted zone, in which there are high density of extended defects. The thickness of the faulted zone is about 0.4μm. Just above this region, the defects density is reduced sharply, and the quality of the layer is improved, which is identified by electron diffraction (ED) patterns. In comparison, Sample A shows about an order lower density of extended defects than Sample B, their columnar diameter is larger and its ED pattern is sharper, too. The buffer layer of Sample B is more smooth than Sample A. The appropriate rougher morphology of the buffer layer may cause that the structural disorder between the high-temperature (HT) grown island and the buffer layer is accommodated by Frank and Shockley partial dislocations. However, the TD is likely to propagate into the HT GaN from the smooth surface of the buffer layer grown after extensively nitridation of substrate. According to the position and width of X-ray diffraction peaks of (0002) and (0004), the size of crystalline grain, D and the residual strain could be calculated. The values of(D,e in)of Sample A and B are (175nm,0.167%) and (90nm,0.141%), respectively. Small size of crystalline grain may be advantageous to relieve the lattice and thermal mismatch stress, but it lead to higher density of extended defects. The width of GaN (0002) reflections of Sample A is 4min lower than that of Sample B. This result may be due to the lower screw TD. The higher density of screw TD may widen the GaN (0002) peak in X-ray rocking curve. In room temperature PL spectra, the ratio of band-edge emission intensity to YL one of Sample A is 3 orders larger than that of Sample B. Furthermore the YL in Sample B is stronger and has fine structure, while that in Sample A is nearly invisible in the PL spectrum. The GaN epilayer with high quality exhibits almost no YL emission. It is well known that the YL corresponds to the deformed crystal structure. We assigned that the screw TD and mixed TD are attributed to the YL referring to our XRD results.

Surface Modification and Significant Reduction of Yellow/Blue Luminescence of Gallium Nitride

Study on GaN Nanostructures: Growth and the Suppression of the Yellow Emission

Reduction of Yellow and Blue Luminescence in Si-doped GaN by Rapid Thermal Annealing

From powder to nanowire: A simple and environmentally friendly strategy for optical and electrical GaN nanowire films

Nature and Elimination of Yellow-Band Luminescence and Donor–acceptor Emission of Undoped GaN

Effect of High-Temperature Annealing on Yellow and Blue Luminescence of Undoped Gan

An InGaN/GaN single quantum well improved by surface modification of GaN films

Lattice-aligned gallium oxynitride nanolayer for GaN surface enhancement and function extension

Microstructural and Optical Properties of GaN Films on Nitrided Sapphire Substrates

Structure and Luminescence of A-Plane GaN on R-Plane Sapphire Substrate Modified by Si Implantation*

Formation and Applications in Electronic Devices of Lattice‐Aligned Gallium Oxynitride Nanolayer on Gallium Nitride

In situ chemical functionalization of gallium nitride with phosphonic acid derivatives during etching

Effects of Si ion implantation and post-annealing on yellow luminescence from GaN

Improving luminescence response in ZnGeN2/GaN superlattices: defect reduction through composition control

Growth of High-Quality Nitrogen-Polar GaN Film by Two-Step High-Temperature Method

Gallium Nitride Films Synthesized by Reactive Pulsed Laser Deposition from A Gaas Target

Effect of Annealing on Photoluminescence Properties of Neon Implanted GaN

Physics and chemistry of nitrogen dioxide (NO2) adsorption on gallium nitride (GaN) surface and its interaction with the yellow-luminescence-associated surface state

Achieving Atomically Flat Surfaces for LiGaO2 Substrates for Epitaxial Growth of GaN Films

Research on Evolution of Relevant Defects in Heavily Mg-Doped GaN by H Ion Implantation Followed by Thermal Annealing

Homo-epitaxial Growth of High Crystal Quality GaN Thin Films by Plasma Assisted–molecular Beam Epitaxy