Abstract:The preparation of precursor sol is the first and crucial step in fabricating oxide fibers by the sol–gel method. In this study, different aluminum-silica sols were prepared by adjusting the alumina and silica source mixing procedure using aluminum carboxylate sol and tetraethoxysilane (TEOS) as the aluminum source and silicon source, respectively. Continuous alumina-mullite precursor fibers were obtained by dry spinning and the effects of alumina and silica source mixing procedure on the phase transition and microstructure evolution of alumina-mullite composite fibers were investigated. The results showed that the mullite formation temperature in the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was about 1300 °C, while it was 800 °C in the fibers obtained by mixing aluminum carboxylate sol and TEOS. In addition, the grain size of the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was significantly smaller than that obtained by mixing aluminum carboxylate sol and TEOS. The mechanism of this difference was that the aluminum-silica sol obtained by adding TEOS during the preparation of aluminum carboxylate sol was a diphasic sol, while the aluminum-silica sol obtained by adding TEOS in the prepared aluminum carboxylate sol was a monophasic sol.Graphical Abstract

Effect of precursor pH on one-dimensional growth of mullite prepared by sol-gel method with WO<SUB>3</SUB> catalyst: Effect of precursor pH on one-dimensional growth of mullite prepared by sol-gel method with WO<SUB>3</SUB> catalyst

Effect of Precursor pH on One-dimensional Growth of Mullite Prepared by Sol-Gel Method with WO_3 Catalyst

Synthesis and Controlled Growth of Mullite Submicron Powders

Morphology-controlled Synthesis and Characterization of MnWO4 Nanocrystals Via a Facile, Additive-Free Hydrothermal Process

Hydrothermal Preparation and Characterization of MnWO4Nanowires

Structural Studies of Wo3-Catalysed Mullite

Fabrication and characterization of porous mullite ceramics with ultra-low shrinkage and high porosity via sol-gel and solid state reaction methods

pH control on preparation of nano-TiO_2 by gel-sol process

Effect of Magnesium Oxide on Preparation of Mullite Fibers Via Sol-Gel Method

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Preparation of Nanometer Mullite Via Supercritical CO2

Effect of Ph in Preparation and Properties of Mesoporous Sieve from Montmorillonite

Preparation of Nanometer Mullite via Supercritical CO<sub>2</sub>

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Effect of pH and sulphate on the morphology of γ-AlOOH

Porous mullite nanopowder for slurry preparation of material direct writing by sol-gel method

Molten salt synthesis of mullite whiskers from various alumina precursors

The Effect of Al Content on the Pore Diameters of the Mesoporous Molecular Sieves Synthesized with Microcline as Starting Material

Mullite Fibers Prepared from an Inorganic Sol–gel Precursor

Mullite Fibers Prepared by Sol-Gel Method Using Aluminum Chloride Aluminum Isopropoxide and Tetraethylorthosilicate

Preparation of Silica Sol and Effect of Preparation Conditions on Its Properties