Abstract:Most countries begin to replace the conventional halogen headlamps with the small-wattage Xe metal halide lamp as the source of the automotive headlamp.However,the design of its electronic ballast is quite complex and the price is very high.As a result,it is only applied to the headlamp of the advance cars.This paper presentes the electronic ballast for automotive lamp using simulation control,and mainly discusses the basal principle and designing way including the basal structure of the ballast circuits and the selection of the topology of the main circuit.The transient process of the Xe lamp during the start-up phase is extremely complex.Therefore,how to complete the control of the start-up process is the difficulty.This paper also presentes the way of the constant power control and igniting.Based on the experimental data from the laboratory prototype,the circuits can complete all the control tasks from the phase of start-up to steady,including the switch of the constant power control,the high voltage of igniting.

Research on FPGA-Based Control Chip of Networked HID Electronic Ballast

Electronic Ballast for MHL Based on ARM Microcontroller

A Digital Controlled Ballast for Metal Halide Lamp

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

The Application of Digital Addressable Lighting Interface in HID Lamps' Electrical Ballast

Design of LED Production Equipment Molding Motion Controller Base on FPGA

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Design of a Digital Controller for High Frequency HID Lamp Ballast

Digital Eectronic Ballast for High Intensity Discharge Lamps

Research on Fully Integrated Digital Control Power Management Chip System Based on FPGA.

Power Control Strategy of Electronic Ballast for HID Lamps

Design of Lighting System Controller Based on Low-voltage Power Line Carrier Communication

HID Electronic Ballast with Power Line Communication Function

Design and Implementation of FPGA Based High-Speed Bus for Control System

A network control system for scene adaptive semiconductor lighting

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

A Research on Digital Bi-directional DC/DC Converter Based on the FPGA Control

Electronic Ballast for Automotive Lamp Using Simulation Control

Development and Research of Lighting System Based on DALI

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy

Research on the Implementation of the Digital controlled DC-DC Converter on FPGA