Abstract:Hydraulic expansion is commonly adopted for the tube to tubesheet expansion in the steam generator of nuclear power plants, and its quality greatly influences the stable and reliable operation of the steam generator. In this paper, an unexpected fracture of the hydraulic expansion mandrel occurred during the hydraulic expansion process, which caused the internal bulge defect (IBD) in the expanding area of the heat exchange tube. The corrosion test results showed that the IBD area had higher susceptibility to stress corrosion cracking (SCC) than the original tubes, which might lead to premature failure of the heat exchange tube in practical operation. To find out the root causes of this failure, the fracture morphologies of the hydraulic expansion mandrel were observed under the optical microscope (OM) and the scanning electron microscope (SEM), and the stress distribution during service were analyzed by mechanical calculation, The results indicated that the hydraulic expansion mandrel was repeatedly loaded by high-pressure medium during service, thus its weakest point was fractured due to high strain level and low cyclic number inelastic strain fatigue. Based on the results, the underlying mechanisms were discussed, and the countermeasures were proposed. The achievements of this paper provide theoretical and practical support for preventing similar failure and ensuring the expansion quality of the steam generator tubes for nuclear power plants.

Study on Stress Intensity of Welding Parts of Small Dlameter Tube to Reheater in Coal-burning Thermo-electric Factory with 200 MW Power

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Analysis on the cause of crack in connection pipeline of subcritical boiler reheater

Analysis of the Vibration Damage Mechanism of the Tube Bundles of a Glycol Re-Boiler

Microstructural and Performance Analysis of TP304H/T22 Dissimilar Steel Welded Joints

Failture Analysis of Welded Joint on Superheater of a 670t/h Boiler

Leakage of water-cooled wall tube in subcritical boiler

Safety Testing and Analysis of the Header of the Drawn Boiler with a Small Diameter and a Large Wall Thickness

Experimental and simulative failure analysis of reformer furnace outlet manifolds serviced in aromatic plant

Failure analysis of reheater tubes in a 350 MW supercritical circulating fluidized bed boiler

Welding Numerical Simulation Analysis of AP 1000 Insert Plate and Penetration Sleeves Based on ABAQUS

Failure Analysis on Abnormal Bursting of Heat Transfer Tubes in Spiral-Wound Heat Exchanger for Nuclear Power Plant

ANALYSIS OF TEMPERATURE FIELD AND THERMAL STRESS FOR EXTERNALLY CONNECTED PIPE SOCKETS OF REHEATER BY USING THE FINITE ELEMENT METHOD

Fatigue Analysis of Welded Joint at Tube-plate of Steam Generator in HTR-10

FEA Design of Flat End Socket on the High Pressure Waste Heat Boiler

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Cause analysis of elbow crack for header's connecting tubes of boiler's reheater concerning 300 mw unit

Computational Analysis of Tube Wall Temperature of Superheater in 1000 MW Ultra-Supercritical Boiler Based on the Inlet Thermal Deviation

Cause and mechanism analysis of cracking and leakage of water wall tube

Failure Analysis on Water Wall Tube Burst of Heating Furnace