Abstract:The thermal conductivity (k) of polycrystalline silicon carbide thin films is relevant for thermal management in emerging silicon carbide applications like MEMS and optoelectronic devices. In such films k can be substantially reduced by microstructure features including grain boundaries, thin film surfaces, and porosity, while these microstructural effects can also be manipulated through thermal annealing. Here, we investigate these effects by using microfabricated suspended devices to measure the thermal conductivities of nine LPCVD silicon carbide films of varying thickness (from 120 - 300 nm) and annealing conditions (as-grown and annealed at 950 degrees Celsius and 1100 degrees Celsius for 2 hours, and in one case 17 hours). Fourier-transform infrared spectroscopy (FTIR) and X-ray diffraction (XRD) spectra and density measurements are also used to characterize the effects of the annealing on the microstructure of selected samples. Compared to as-deposited films, annealing at 1100 degrees Celsius typically increases the estimated grain size from 5.5 nm to 6.6 nm while decreasing the porosity from around 6.5% to practically fully dense. This corresponds to a 34% increase in the measured thin film thermal conductivity near room temperature, from 5.8 W/m-K to 7.8 W/m-K. These thermal conductivity measurements show good agreement of better than 3% with fits using a simple theoretical model based on kinetic theory combined with a Maxwell-Garnett porosity correction. Grain boundary scattering plays the dominant role in reducing the thermal conductivity of these films compared to bulk single-crystal values, while both grain size increase and porosity decrease play important roles in the partial k recovery of the films upon annealing. This work demonstrates the effects of modifying the microstructure and thus the thermal conductivity of silicon carbide thin films by thermal annealing.

The effects of annealing disposition on α-SiC thin films prepared by pulsed laser deposition

Optimal temperature of crystallization and photoluminescence of SiC/Si (100) film prepared by pulsed ArF excimer laser deposition

Effect of Annealing on SiC Thin Films Prepared by Pulsed Laser Deposition

Thermochemical process occurring in PLD-derived SiC films during vacuum annealing

Growth of SiC Thin Films on (100) and (111) Silicon by Pulsed Laser Deposition Combined with a Vacuum Annealing Process

Influence of annealing on microstructures and photoluminescence of nano-composite silicon film

The Annealing Effect of Crystal 4H-Sic Films Prepared by Pulsed Laser Deposition

Effect of annealing on microstructure and photoluminescence of nano-composite silicon film

Influence of annealing temperature on the structure and photoluminescence properties of SiC films

Annealing Effect on Optical and Electronic Properties of Silicon Rich Amorphous Silicon-Carbide Films

High temperature annealing of hydrogenated amorphous silicon carbide thin films

Structural Relaxation of Amorphous Silicon Carbide Thin Films in Thermal Annealing

Low-temperature Annealing of Polycrystalline Si/sub 1-X/ge/sub X/ after Dopant Implantation

Effects of thermal annealing on thermal conductivity of LPCVD silicon carbide thin films

The Preparation of Single-Crystal 4H-Sic Film by Pulsed XeCl Laser Deposition

Structure and photoluminescence properties of SiC films synthesized by the RF-magnetron sputtering technique

Effect of laser annealing on amorphous silicon carbide films prepared by PECVD

Effect of Annealing Temperature on Photoluminescence Performance and Structure of Si-rich Silicon Nitride

Thermal effect on RF sputtered SiC film

The Effect of Annealing Temperature on Micro-Structure and Mechanical Properties of C/Sic Composites

Effects of annealing processing on morphological, compositional and Schottky characterization of PtSi/Si diodes