Abstract:In this paper, an equivalent welding model is proposed that takes the tensile stress and strain parameters of the axial weld area of the roll-welded bellows as the material properties to replace welding simulation. The integrated finite element method is used to simulate the following two model forming processes for the roll-welded bellows: (i) welding-bulging-repeated bending model, and (ii) equivalent welding-bulging-repeated bending model. The stress and strain distributions of the two models are compared and analyzed, and the main failure areas of the roll-welded bellows in the repeated bending process are predicted. At the same time, the accuracy of the model prediction is verified by the limited repeated bending test of the roll-welded bellows, and the failure mechanism of the roll-welded bellows is revealed. The results indicate that the stress and strain distributions of the two models are essentially the same, thus verifying the feasibility of the equivalent welding model. When the cyclic deformation reaches the limit, the predicted stress failure risk zone is located at the base metal position of the first wave-like trough of the bellows near the heat affected zone at the fixed end, which is consistent with the experimental results. This indicates that the equivalent welding-bulging-repeated bending model can accurately predict the position of the repeated bending fatigue failure of the bellows, thus laying a foundation for the optimization of the roll-welded bellows.

Calculation of Free-Bend Load for Tailor Welded Blanks with Dissimilar Thickness

Load-carrying capacity of welded hollow spherical joints subject to combined planar tri-directional axial force and bending moment

Load-carrying Capacity and Practical Calculation Method of Welded Hollow Spherical Joints with Square Steel Tubes Subjected to Combined Axial Forces and Biaxial Bending Moments

Parameters Optimization of Tailor Welded Blank Forming Process

Study on Formability of Tailor Welded Blanks Based on Numerical Simulation

Experimental Investigation on the Mechanical Properties of Weld Metal in Tailor Welded Blanks

The Forming Limits Prediction Model for Tailor Welded Blank with Straight Seam

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Research on Formability of Tailor-welded Blanks with Different Thickness in Door Inner Stamping

Numerical Simulation on Formability of Tailor-Welded Blank with Curved Weld-Line under Different Blank Holder Forces

Impact Modeling of the Weld Line of Tailor-Welded Blank

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Investigation on the Formability of Tailor-Welded Blanks

Finite element calculation and regression analysis on stress concentration factors of undermatching butt joints

Shape design of the reinforcement for bending load-carrying capacity of under-matched butt joint under four-point bending load

Numerical Simulation and Experimental Study on the Weld-Line Movement of Tailor-Welded Blank

Experimental and Numerical Investigation on Fatigue Performance of Non-Load-carrying Fillet Welded Joints

Finite element simulation prediction of repeated bending failure zone of roll-welded bellows based on an equivalent welding model

PLASTIC LIMIT LOAD EQUATIONS OF DEFECT FREE ELBOWS SUBJECTED TO IN-PLANE BENDING MOMENT

U-shaped pieces of TWB bend forming and springback compensation and the law of weld movement

Research on the non-uniform deformation of deep drawing tailor-welded square boxes