Abstract:This investigation delves into the residual stresses that arise during the deep drawing process of laser-welded blanks (LWBs) using a combination of experimental and numerical methods. While LWBs are preferred for their low distortion and high-quality welds, they are subjected to detrimental residual stresses during forming operations that can adversely affect their service life. The primary objective of this study is to evaluate the influence of five essential process parameters, namely welding power, welding speed, blank holder forces (BHF), friction coefficient, and material properties, on the residual stresses that are generated during the welding and forming of LWBs. Moreover, the study seeks to optimize these process parameters for the deep drawing process utilized in this investigation using response surface methodology (RSM). The hole-drilling method, a commonly used experimental technique for measuring residual stresses, was employed in this study to measure the residual stresses in different zones of laser-welded blanks (LWBs). The measurements were performed using a strain gauge rosette and were repeated three times to ensure accuracy. In addition, the Simufact package and Abaqus Unified FEA software are utilized to simulate the laser beam welding and forming processes, respectively. The close alignment between experimental and simulated outcomes suggests that the model is suitable for numerical simulation of the LWB deep drawing process (less than 10%). By conducting an analysis of variance, the main factors that influence the residual stresses in the welding and forming processes are identified. The findings suggest that welding power–welding speed (30.89%) and BHF (21.65%) have the most significant impact on residual stresses. Furthermore, selecting BHF = 50140.67N, friction coefficient = 0.2, welding speed = 7.4 mm/s, and welding power = 144.79W can enhance the confidence coefficient of the welding zone design.

Research on the non-uniform deformation of deep drawing tailor-welded square boxes

Reverse Deformation Design for Bending Control in Welding of Ring Stiffeners

Study on Formability of Tailor Welded Blanks Based on Numerical Simulation

Numerical investigation of controllable non-uniform deformation of tailor-welded blanks using heterogeneous pressure-carrying medium

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Numerical analysis of stress & strain and thickness variation in single point incremental forming of tailor welded steel blanks

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Research on the Critical Blank Holder Force of Elliptical Heads

Insight into the Key Process Parameters on Residual Stress Distribution in Deep Drawing of Laser-Welded Blanks: Response Surface Modeling

Study on Deep drawing Forming Process of Wheel Disks

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Improving parameters for achieving uniform cylindrical cup wall thickness in two-step deep drawing processes with SPCC sheet material

Comparison between laser beam and gas tungsten arc tailored welded blanks via deep drawing

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Investigation on the Formability of Tailor-Welded Blanks

The Forming Limits Prediction Model for Tailor Welded Blank with Straight Seam

Finite Element Analysis of the Deep-drawing Stress of QT8812 Automobile Engine Oil Pan

Finite element analysis of the thin-wall components’s deformation during the multi point flexible processing

Numerical simulation of bending deformation induced by multi-seam welding of a steel-pipe structure