Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Finite element analysis of the thin-wall components’s deformation during the multi point flexible processing

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Study on Milling Deformation of Aerospace Frame Monolithic Components

Modal Analysis and Vibration Control of the Thin-wall Components During the Multipoint Flexible Processing

Investigation of Moving Fixture on Deformation Suppression During Milling Process of Thin-Walled Structures

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Finite Element Simulation for Optimal Clamping Scheme of Thin-Walled Workpiece in Milling Process

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

602 FEM-based Simulation for Workpiece Deformation in Thin-Wall Milling

Machining deformation of single-sided component based on finishing allowance optimization

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Surface Topography Prediction Model in Milling of Thin-Walled Parts Considering Machining Deformation

Numerical Analysis of Coupled Finite Element with Meshfree in Bulging Process of Sheet Elastic Flexible-Die Forming

Finite Element Simulation and Deformation Control of High-Speed Milling of Al7050-T7451 Thin-walled Parts

Finite element analysis of residual stresses and thin plate distortion after face milling

Finite Element Simulation of Bending Thin-Walled Parts and Optimization of Cutting Parameters

Machining deformation control methods and analysis of a thin-walled gear spoke plate

Investigation of Shearing Extrusion Forming Process Using Finite Element Method

Precise local deformation control for UHSS thin-walled component in roll forming

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Rapid Finite Element Analysis of Bulk Metal Forming Process Based on Deformation Theory