Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

Bai Wanjin,Ke Yinglin,Wu Hongbing,Dong Huiyue

DOI: https://doi.org/10.3321/j.issn:1004-132X.2009.02.021

2009-01-01

Abstract:To study the part deflection during milling process of low rigidity parts,a new three dimensional(3-D) finite element analysis(FEA) model of an I-sectional thin-walled workpiece was presented.Both the so called symmetry and step-symmetry milling processes were simulated with the FEA method.Key factors,such as cutting loads,sequences and paths were synthetically taken into account.Simulation results indicate that the maximum deflection occurring on the middle of the thin-walled workpiece.With step-symmetry milling method,it can be significantly reduced the part deflections.The magnitudes,as well as distributions,of the residual stress have little differences between symmetry and step-symmetry milling processes.Based on the FEA simulation results and numerical control(NC) machining compensation methods,the aluminum thin-walled workpiece can be machined in an economical,high efficiency and quality way.