Abstract:Metal additive manufacturing finds its applications in various sectors, especially the automotive and aerospace industries, wherein weight reduction of components is of paramount importance with respect to performance and fuel consumption. However, additively manufactured metallic components usually undergo post-processing steps to make them ready for end use application. One of these steps is finish machining that is employed to overcome the surface irregularities and poor tolerances produced as a result of additive manufacturing (AM). These finish machining processes involve turning, milling, drilling, reaming, or grinding. This paper presents a three-dimensional (3D) finite element (FE) model to simulate the chip formation during the milling of an AM aluminum alloy AlSi10Mg, while taking microstructural porosity defects into consideration. The material was chosen for its significance in the aerospace and automotive industries. The proposed numerical model was developed using ABAQUSTM and is capable of predicting the cutting forces during the milling of AM AlSi10Mg. The Johnson-Cook strength and fracture models were utilized to simulate the deformation mechanics of the workpiece material subjected to high strains, high strain rates, and high temperatures caused by machining. Two algorithms have been proposed and discussed to model the microstructural defects in the AM metal. Machining tests were performed on an AM AlSi10Mg specimen block to validate the proposed finite element model. To further demonstrate the capability of the proposed model in capturing the influence of porosity on cutting forces, a study has been conducted revolving around the impact of different pore sizes. The chips produced during the machining tests were also collected to compare the morphologies between the numerically simulated chips and the ones obtained experimentally, to further strengthen the validity of the proposed model.

Numerical Simulation for the Milling of Alluminum Alloy Thin-Wall Workpiece with Two and Four Flutes Helical Cutter

Analysis of milling forces in slot milling of aluminum alloy with three flutes cutter

Trochoid-path-based FEM Simulation for High-Speed Milling of Aluminum Alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Numerical Simulation of Cavity-Filling Procedures for Micro-Pin-fin Array Thixoforming with Semi-Solid A356 Aluminium Alloy

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Research on 3D Numerical Simulation and Experiment of Cutting Temperature for High Speed Milling of Aerospace Aluminum Alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Finite Element Simulation of Serrated Chip Formation in High-speed Milling of A lloy Cast Iron

Effects of Tool Flank Wear on Orthogonal Cutting Process of Aluminum Alloy

Numerical simulation and tool parameters optimization of aluminum alloy transmission intermediate shell

602 FEM-based Simulation for Workpiece Deformation in Thin-Wall Milling

Finite Element Simulation and Deformation Control of High-Speed Milling of Al7050-T7451 Thin-walled Parts

Milling of additively manufactured AlSi10Mg with microstructural porosity defects, finite element modeling and experimental analysis

Finite element simulation and experimental investigation on cutting mechanism in vibration-assisted micro-milling