Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Superhard and tougher SiC/diamond-like-carbon composite films produced by electron beam physical vapour deposition

Preparation of Anti-Reflective and Protective Diamond-Like Carbon Film on Si Substrate by Femto-Second Pulsed Laser Deposition

Surface Hardness Enhancement in Sp3-Bonded Carbon Doped SiC Nanocomposite Films

Interface architecture for superthick carbon-based films toward low internal stress and ultrahigh load-bearing capacity

Investigation of the Mechanical and Tribological Properties of Diamond-Like Carbon Films on YG8 and High-Speed Steel Substrates with W Buffer Layers

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Influence of Cr Contents and Nanograin Sizes on Microstructure, Mechanical and Sliding Tribological Behaviors of Hard Cr-Diamond-Like Carbon Films

Study on composition, microstructure and hardness of DLC films by vcad

Diamond-like Carbon Films Deposited by Femtosecond Laser Pulses

Preparation, Characterization and Tribological Properties of Diamond-Like Carbon Film on AZ31 Magnesium Alloy

GIAXD and XPS Characterization of Sp3c Doped SiC Superhard Nanocomposite Film

High temperature tribology behavior of silicon and nitrogen doped hydrogenated diamond-like carbon (DLC) coatings

Preparation of silicon carbide and tantalum carbonitride composite with high hardness and moderate elastic modulus by laser chemical vapor deposition for anti-erosion protective coatings

Effects of melting temperature on mechanical properties and bond structures of DLC Films: A molecular dynamic simulation

A Study of Hard Diamond-Like Carbon Films in Mid-Frequency Dual-Magnetron Sputtering

Deposition of Diamond-Like Carbon Films Using Hollow Cathode Plasma Source

Study on W Graded Doping Dlc Composite Films with Multicomponent Transition Layer

The Influence of Deposition Temperature on the Microscopic Process of Diamond-like Carbon (DLC) Film Deposition on a 2024 Aluminum Alloy Surface

Hardening of Cr–Cu–Al–Fe–O High-Entropy Composite Films

Microstructure, wear and corrosion behavior of nano-CeO2 doped diamond-like carbon (DLC) composite films