Abstract:A series of tungsten-gradually doped diamond-like carbon (DLC) films with functionally graded interlayer were prepared using a hybrid technique of vacuum cathodic arc/magnetron sputtering/ion beam deposition. With ‘compositionally graded coating’ concept, the deposition of wear-resistant carbon-based films with excellent adhesion to metallic substrate was realized. In the films, a functionally graded interlayer with layer sequence of Cr/CrN/CrNC/CrC/WC was first deposited onto the substrate, and then, a DLC layer doped with gradually decreasing content of W was coated on. The W concentration gradient along depth of the film was tailored by adjusting the W target current and deposition time. The characterized results indicate that the microstructural, mechanical and tribological properties of these films show a significant dependence on the W concentration gradient. A high fraction of W atom in carbon matrix can promote the formation of sp2 sites and WC1−x nanoparticles. Applying this coating concept, strongly adherent carbon films with critical load exceeding 100N in scratch test were obtained, and no fractures or delaminations were observed at the end of the scratched trace. The hardness was found to vary from 13.28 to 32.13GPa with increasing W concentration. These films also presented excellent tribological properties, especially significantly low wear rate under dry sliding condition against Si3N4 ball. The optimum wear performance with friction coefficient of 0.19 and wear rate of 8.36×10−7 mm3/Nm was achieved for the tungsten-gradually doped DLC film with a graded W concentration ranging from 52.5% to 17.8%. This compositionally graded coating system might be a potentially promising candidate for wear-resistant carbon-based films in the demanding tribological applications.

Microstructure, wear and corrosion behavior of nano-CeO2 doped diamond-like carbon (DLC) composite films

Microstructure and characterization of La2O3 and CeO2 doped diamond-like carbon nanofilms

Microstructure and mechanical properties of CeO2 doped diamond-like carbon films

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Electrodeposition, microstructure, friction and electrochemical behavior of diamond-like carbon (DLC) films with Ni/Cu interlayer

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Effect of Ultra-fine WC Particles on Microstructural Evolution and Wear Behavior of Ni-Based Nano-CeO2 Coatings Produced by Laser

Microstructural evolution and tribology of Mo-doped diamond like carbon nanocomposite film

Electrodeposition, microstructure and tribological performance of Ni/(N) incorporated diamond-like carbon films

Nanomechanical and Electrochemical Properties of Diamond-Like Carbon (DLC) Films Deposited by Plasma Enhanced Chemical Vapor Deposition (PECVD) Technique

Nano-tribology Study of Ultrathin Diamond-like Carbon (DLC)

Unusual Stress Behaviour of CeO2-doped Diamond-Like Carbon Nanofilms

Influence of Cr Contents and Nanograin Sizes on Microstructure, Mechanical and Sliding Tribological Behaviors of Hard Cr-Diamond-Like Carbon Films

Microstructural, Mechanical and Tribological Properties of Tungsten-Gradually Doped Diamond-Like Carbon Films with Functionally Graded Interlayers

Structural Characterization And Properties Enhancement Of Diamond-Like Carbon-Films Synthesized Under Low-Energy Ne+ Bombardment

Enhanced tribological and corrosion properties of DLC/CrN multilayer films deposited by HPPMS

A study of the wear mechanism of diamond-like carbon films

Growth and Tribological Property Characterization of Diamond-Like-Carbon Films

Micro/Nanomechanical and Tribological Properties of Thin Diamond-Like Carbon Coatings

Unusual Stress Behaviour of La2O3- and CeO2-doped Diamond-Like Carbon Nanofilms

Effect of PDDA‐MWCNTs concentration on the microstructure and friction behavior of Co‐doped diamond‐like carbon (Ni/N/MWCNTs‐DLC) films