Abstract:Different machining processes were used in the single crystal SiC wafer machining. SEM was used to observe the surface morphology and a cross-sectional cleavages microscopy method was used for subsurface cracks detection. Surface and subsurface cracks characteristics of single crystal SiC wafer in abrasive machining were analysed. The results show that the surface and subsurface cracks system of single crystal SiC wafer in abrasive machining including radial crack, lateral crack and the median crack. In lapping process, material removal is dominated by brittle removal. Lots of chipping pits were found on the lapping surface. With the particle size becomes smaller, the surface roughness and subsurface crack depth decreases. When the particle size was changed to 1.5µm, the surface roughness Ra was reduced to 24.0nm and the maximum subsurface crack was 1.2µm. The efficiency of grinding is higher than lapping. Plastic removal can be achieved by changing the process parameters. Material removal was mostly in brittle fracture when grinding with 325# diamond wheel. Plow scratches and chipping pits were found on the ground surface. The surface roughness Ra was 17.7nm and maximum subsurface crack depth was 5.8 µm. When grinding with 8000# diamond wheel, the material removal was in plastic flow. Plastic scratches were found on the surface. A smooth surface of roughness Ra 2.5nm without any subsurface cracks was obtained. Atomic scale removal was possible in cluster magnetorheological finishing with diamond abrasive size of 0.5 µm. A super smooth surface eventually obtained with a roughness of Ra 0.4nm without any subsurface crack.

Characterization Techniques and Methods on Single Crystal Surface Machined Damages

Method of Damage Characterization of Engineering Ceramics Grinding Surface

Evaluation and Measurement of Surface/Subsurface Crack Damage of Ground Ceramics

Analysis on Ground Surface Damage of Quartz Fiber-Reinforced Quartz Composites

A Study on the Surface Quality and Damage Properties of Single-Crystal Silicon Using Different Post-Treatment Processes

Influence mechanism of defects on the subsurface damage and structural evolution of diamond in CMP process

Modeling and Analysis of Uncertainty in On-Machine Form Characterization of Diamond-Machined Optical Micro-Structured Surfaces

Mechanism of Surface Defects in Ultra-Precision Machining of Sesquioxide Laser Crystal Tm: GdScO3

Investigation on surface generation mechanism of single-crystal silicon in grinding: Surface crystal orientation effect

Molecular dynamics study of crystal orientation effect on surface generation mechanism of single-crystal silicon during the nano-grinding process

X-ray Scattering from a Rough Surface and Damaged Layer of Polished Wafers

Subsurface Damage Structure and Eliminating

Sub-surface Damage of Ultra-Thin Monocrystalline Silicon Wafer Induced by Dry Polishing

INFLUENCE OF SUB-SURFACE DAMAGE ON TEXTURING OF MONOCRYSTALLINE SILICON WAFERS FOR SOLAR CELLS

Characterization of manufacturing-induced surface scratches and their effect on laser damage resistance performance of diamond fly-cut KDP crystal

Effect of Subsurface Damages in Seed Crystals on the Crystal Quality of 4H-Sic Single Crystals Grown by the PVT Technology

Topic Review: Application of Raman Spectroscopy Characterization in Micro/Nano-Machining

Surface damage mechanism of monocrystalline silicon during single point diamond grinding

Study on the relationship between the damage of machined surface layer and the dispersion curve of laser-induced surface acoustic wave

Surface and subsurface cracks characteristics of single crystal SiC wafer in surface machining

Molecular dynamics simulation of subsurface damage mechanism during nanoscratching of single crystal silicon