Abstract:Ultra-low-power circuits that can work under a low-voltage supply are in great demand in future wearable biomedical applications, which tend to be integrated with low-output-voltage energy harvesting devices. In this paper, we present a low-voltage low-power continuous-time low-pass filter (CT-LPF), which is indispensable in biomedical systems. When a low-voltage supply is used, it is necessary to make the output quiescent voltage (V-Q) stable in the LPF, otherwise the dynamic range will be reduced. Conventional Source-follower (SF) based topologies can achieve ultra-low-power consumption. However, the difference of the input and output V-Q is sensitive to process and temperature variations. In this work, a complementary SF based topology with a bulk-common-mode-feedback (B-CMFB) circuit is proposed to keep the output V-Q tracking the input V-Q and immune to the process and temperature variations. A 4th-order LPF using the proposed topology has been implemented in a standard 0.18 mu m CMOS process, which achieves a power consumption of only 3.69-nW under a 0.5-V voltage supply with a bandwidth of 200 Hz. Measurement results show that the input-referred noise is 91.9 mu V-rms. The IIP3 is 5.0 dBm and the dynamic range (DR) is 48.5 dB. The active chip area is only 0.074 mm(2). The proposed LPF achieves both ultra-low power consumption with a 0.5-V supply and a stable output V-Q immune to process and temperature variations, which is suitable for low-supply-voltage biomedical systems.

A Low Power Programmable Band-Pass Filter with Novel Pseudo-Resistor for Portable Biopotential Acquisition System.

A Programmable Low Power Current Source for Bioimpedance Measurement: Towards a Wearable Personalized Health Assistant.

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A High-pass Filter with On-chip Body Bias Technique for Neural Signals Processing

Bio-Patch Design and Implementation Based on a Low-Power System-on-Chip and Paper-Based Inkjet Printing Technology

Design of a Low Noise Bio-Potential Recorder With High Tolerance to Power-Line Interference Under 0.8 V Power Supply

A 1.8-V 770-nW biopotential acquistion system for portable applications

A 0.5-V 3.69-nW Complementary Source-Follower-C Based Low-Pass Filter for Wearable Biomedical Applications

Design of an Analog Front-End for Ambulatory Biopotential Measurement Systems

A low power analog front-end for portable biopotential acquisition systems

A 0.5-V Ultra-Low-Power Low-Pass Filter with a Bulk-Feedback Technique

0.28-nW level-shifter folded flipped source follower fourth-order low-pass-filter IC design

A Low-Power Portable ECG Sensor Interface with Dry Electrodes

Design of Ultra-Low Power Biopotential Amplifiers for Biosignal Acquisition Applications

Design of Ultra-Low-Power Electrocardiography Sensors

A Low-Power Low-Noise Amplifier for EEG/ECG Signal Recording Applications

Low quiescent current LDO with FVF-based PSRR enhanced circuit for EEG recording wearable devices

A Low Power Low Noise Analog Front End for Portable Healthcare System

A 10 kHz bandwidth low-power active negative feedback front-end amplifier based on unipolar IZO TFT technology

A High Linearity Large Time Constants Switched-Resistor Filter for Biomedical Applications

A 1.8 Μw 32 Nv/√hz Current-Reuse Capacitively-Coupled Instrumentation Amplifier for EEG Detection