Abstract:Ultra-low-power circuits that can work under a low-voltage supply are in great demand in future wearable biomedical applications, which tend to be integrated with low-output-voltage energy harvesting devices. In this paper, we present a low-voltage low-power continuous-time low-pass filter (CT-LPF), which is indispensable in biomedical systems. When a low-voltage supply is used, it is necessary to make the output quiescent voltage (V-Q) stable in the LPF, otherwise the dynamic range will be reduced. Conventional Source-follower (SF) based topologies can achieve ultra-low-power consumption. However, the difference of the input and output V-Q is sensitive to process and temperature variations. In this work, a complementary SF based topology with a bulk-common-mode-feedback (B-CMFB) circuit is proposed to keep the output V-Q tracking the input V-Q and immune to the process and temperature variations. A 4th-order LPF using the proposed topology has been implemented in a standard 0.18 mu m CMOS process, which achieves a power consumption of only 3.69-nW under a 0.5-V voltage supply with a bandwidth of 200 Hz. Measurement results show that the input-referred noise is 91.9 mu V-rms. The IIP3 is 5.0 dBm and the dynamic range (DR) is 48.5 dB. The active chip area is only 0.074 mm(2). The proposed LPF achieves both ultra-low power consumption with a 0.5-V supply and a stable output V-Q immune to process and temperature variations, which is suitable for low-supply-voltage biomedical systems.

A High Linearity Large Time Constants Switched-Resistor Filter for Biomedical Applications

Switched-loop filter for automatically frequency-calibrated phase-locked loops

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

Novel Microstrip Lowpass Filter Using Stepped Impedance Resonator And Spurline Resonator

A Wide Linear Range Ultra-low Transconductance Amplifier for Biomedical Sensor Applications

Design of a Programmable and Low-Frequency Filter for Biomedical Signal Sensing Applications.

A Reconfigurable-Band Analog Filter Standard-Cell Based on Differential/Single Input Signaling

Low-Power Programmable Linear-Phase Filter Designed for Fully Balanced Bio-Signal Recording Application

A 0.5-V 3.69-nW Complementary Source-Follower-C Based Low-Pass Filter for Wearable Biomedical Applications

A Low Power Programmable Band-Pass Filter with Novel Pseudo-Resistor for Portable Biopotential Acquisition System.

Second Order Low Pass RC Active Filter for Low Frequency Signal Processing

A High Linearity and Low Noise Anti-Aliasing Filter for ADCs

A 0.5-V Ultra-Low-Power Low-Pass Filter with a Bulk-Feedback Technique

0.279 nW fourth-order filter circuit for biological signal conditioning

Design of A Reconfigurable Filtering Switch with Sharp Rejection and Wide Stopband

A Highly Linear 0.9V 3Rd-Order Acitve-RC Low-Pass Filter in CMOS 28Nm

Design of a Switchable Filter for Reflectionless-Bandpass-to-Reflectionless-Bandstop Responses

A High Linearity Active-Rc Bpf With 70mhz Center Frequency And 22mhz Bandwidth In 65nm Cmos

A New Low-Power Non-uniform Sample and Hold Circuit for Biomedical Signal Processing Applications

A 0.18-&Amp;#x003bc;m CMOS Multirate Filter Bank Asic for Biomedical Applications

High-Performance Low-Pass Filter Using Stepped Impedance Resonator and Defected Ground Structure