Abstract:This paper presents an ultra-low power incremental ADC for biosensor interface circuits. The ADC consists of a resettable second-order delta-sigma (Delta Sigma) modulator core and a resettable decimation filter. Several techniques are adopted to minimize its power consumption. A feedforward path is introduced to the modulator core to relax the signal swing and linearity requirement of the integrators. A correlated-double-sampling (CDS) technique is applied to reject the offset and 1/f noise, thereby removing the integrator leakage and relaxing the gain requirement of the OTA. A simple double-tailed inverter-based fully differential OTA using a thick-oxide CMOS is proposed to operate in the subthreshold region to fulfill both an ultra-low power and a large output swing at 1.2 V supply. The signal addition before the comparator in the feedforward architecture is performed in the current domain instead of the voltage domain to minimize the capacitive load to the integrators. The capacitors used in this design are of customized metal-oxide-metal (MOM) type to reach the minimum capacitance set by the kT/C noise limit. Fabricated with a 1P6M 0.18 mu m CMOS technology, the presented incremental ADC consumes 600 nW at 2 kS/s from a 1.2 V supply, and achieves 68.3 dB signal to noise and distortion ratio (SNDR) at the Nyquist frequency and an FOM of 0.14 pJ/conversion step. The core area is 100 x 120 mu m(2.)

A 1.8-V 770-nW biopotential acquistion system for portable applications

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

A 10-Bit 250-KS/s 1.24-uW SAR ADC for IoT Sensors with Energy-Efficient Comparator.

A 455 Nw 220 Fj/conversion-Step 12 Bits 2 Ks/s SAR ADC for Portable Biopotential Acquisition Systems

A Low-power High-resolution Band-pass Sigma-delta ADC for Accelerometer Applications

A 5ks/s 112nw Sar Adc for Portable Bio-Potential Acquisition System

A low power analog front-end for portable biopotential acquisition systems

Design of an Analog Front-End for Ambulatory Biopotential Measurement Systems

Design of a Low Noise Bio-Potential Recorder With High Tolerance to Power-Line Interference Under 0.8 V Power Supply

Design of an Ultra-Low Power SAR ADC for Biomedical Applications

Design of Ultra-Low Power Biopotential Amplifiers for Biosignal Acquisition Applications

A 1.2 V 600 Nw 12-Bit 2 Ks/s Incremental ADC for Biosensor Application

A 1.7μW/Channel Time-Division-Multiplexing Analog Front-End for Bio-Potential Recording

A 10-bit 1kS/s-30kS/s successive approximation register analog-to-digital converter for biological signal acquisition

A 0.6-V 8.3-ENOB Asynchronous SAR ADC for Biomedical Applications

A Low Power Low Noise Analog Front End for Portable Healthcare System

A low-offset analogue front-end IC for multi-channel physiological signal acquisition

A Low Power Programmable Band-Pass Filter with Novel Pseudo-Resistor for Portable Biopotential Acquisition System.

A 14.9μw Analog Front-End with Capacitively-Coupled Instrumentation Amplifier and 14-Bit SAR ADC for Epilepsy Diagnosis System

A Low Power 10-Bit 100-Ms/s SAR ADC in 65nm CMOS

A 3.6 Μw 60 Nv/sqrthz Capacitively-Coupled Instrumentation Amplifier for Biopotential Signal Recordings.