Abstract:Silicon carbide (SiC), an important semiconductor material used in high-power devices, faces the problem of gate oxygen layer formation in traditional Si MOS devices. In view of this, an innovative approach was adopted in the present work to replace the conventional SiO 2 as the gate oxygen layer with a high-k material (ZrO 2 ) so as to investigate its effect on the electrical characteristics of the appliance. In particular ZrO 2 films were deposited on SiC and Si substrates by atomic layer deposition (ALD), and Al was used as the electrode. The atomic force microscopy (AFM) microregion scan revealed a highly flat surface with Rq<1 nm after the ALD growth of ZrO 2 layer. The sample surface analysis via X-ray photoelectron spectroscopy (XPS) suggested the presence of a small amount of ZrO x components. According to the electron energy loss spectrum (EELS), the band gap width (Eg) of this ALD ZrO 2 dielectric was 5.45 eV, which met the requirements for high-quality 4H-SiC-related MOS devices. The electrical properties of the samples were then studied, and the maximum breakdown electric field of the MOS capacitor structure on the SiC substrate was obtained to be more than 10 MV/cm, i.e., nearly twice that of the Si substrate. Based on capacitance-voltage (C-V) measurements, the interface defect density (Dit) near the conduction band of the MOS capacitive structure of the SiC substrate was only on the order of 10 12 eV -1 cm -2 . The movable charge Neffof the oxide layer was also controlled at 10 12 cm -2 . Therefore, the overall performance of the ZrO 2 /SiC structure in terms of electrical properties exceeds that of the ZrO 2 /Si structure and previously reported counterparts. Thus, the combination of the high-k material (ZrO 2 ) and SiC as the substrates in MOS capacitor structures is a very promising research direction.

Enhanced Dielectric Properties of ZrO2thin Films Prepared in Nitrogen Ambient by Pulsed Laser Deposition

Fabrication and Characterization of Y2O3 Stabilized ZrO2 Films Deposited with Aerosol-Assisted MOCVD

Structure and Dielectric Properties of Ultra-Thin ZrO2 Films for High- K Gate Dielectric Application Prepared by Pulsed Laser Deposition

Structure and dielectric properties of Zr-Al-O thin films prepared by pulsed laser deposition

The Effects of Oxygen Partial Pressure and Substrate Temperature on the Structural and Optical Properties of Zno Films

Pulsed Laser Deposited Zralon Films for High-K Gate Dielectric Applications

Pulsed Laser Deposition of Zirconium Silicate Thin Films As Candidate Gate Dielectrics

Dielectric Properties of SrZrO3 Thin Films Prepared by Pulsed Laser Deposition

Structure and Dielectric Property of High-k ZrO2 Films Grown by Atomic Layer Deposition Using Tetrakis(Dimethylamido)Zirconium and Ozone

Thermal Stability and Electrical Properties of Zr Silicate Films for High- K Gate-Dielectric Applications, As Prepared by Pulsed Laser Deposition

Structural, Optical and Electrical Properties of High-K ZrO2 Dielectrics on Si Prepared by Plasma Assisted Pulsed Laser Deposition

Dielectric properties of Zr–Sn–Ti–O thin films prepared by pulsed laser deposition

Laser-induced damage threshold of ZrO2 thin films prepared at different oxygen partial pressures by electron-beam evaporation

Microstructure and Young's Modulus of ZrN Thin Film Prepared by Dual Ion Beam Sputtering Deposition

Fabrication and Characterization of Zr-Rich Zr-Aluminate Films for High-Kappa Gate Dielectric Applications

Interfacial Properties of High-K Dielectric Cazrox Films Deposited by Pulsed Laser Deposition

Thermal stability and dielectric properties of ultrathin CaZrO x films prepared by pulsed laser deposition

Electronic properties of ZrO<sub>2</sub> films fabricated via atomic layer deposition on 4H-SiC and Si substrates

Electronic Properties of ZrO2 Films Fabricated via Atomic Layer Deposition on 4H-SiC and Si Substrates

Effect of Sputtering Ambient on The Properties of N Doped ZnO Thin Films

Role of Fluoride Doping in Low-Temperature Combustion-Synthesized ZrO x Dielectric Films