Abstract:Composite cylindrical pressure hulls are thin-walled structures widely used for autonomous underwater vehicles. Buckling failure is one of the most important failure modes for these shells under external pressure. In existing buckling studies of cylindrical pressure hulls, FEM is the most popular analysis method but not efficient enough when dealing with structures with complex material distributions such as the variable stiffness composite shells. Motivated by this, an isogeometric method for buckling prediction and post-buckling analysis of variable stiffness composite underwater pressure shell is proposed in this article. In this method, based on Reissner-Mindlin shell formulas undergoing large deformation, a buckling analysis framework in IGA forms is established. Then a modified arc-length method is proposed based on kinematics used in the shell formulas, and is used to overcome the inaccuracy caused by the 2 degrees of freedom node rotation in the prediction step of arc-length method. In addition, the influence of bifurcation is considered, which may seriously affect the precision of buckling behavior simulation when the limit point is close to a bifurcation point. The computational accuracy of this framework has been validated in a series of constant stiffness composite shell cases involving buckling load prediction and post-buckling behavior simulation. For variable stiffness composite hull cases, this framework achieves the same precision as FEM with fewer elements. Therefore, the proposed framework provides an efficient way for the buckling design of underwater variable stiffness composite pressure hulls.

Separation of Primary Stress in Finite Element Analysis of Pressure Vessel with the Principle of Superposition

Stresses Controllable Analysis and Optimal Design of Unique High Pressure Vessel Applied in Hydrogen Charge Station

Discussion on the Implementation of the Primary Structure Method in Design by Analysis

Primary structure method of stress classification for design by analysis

Finite Element Analysis of Tangential Rectangle Joint Pipe on the Shell of an Cyclone

A New Pressure Vessel Design by Analysis Method Avoiding Stress Categorization

Finite Element Calculation and Strength Evaluation of the Local Stress in the Support Locations of Vessels

Advances in "design by Analysis" Methods for Pressure Vessels

Primary structure an important concept to distinguish primary stresses

Stress Analysis and Strength Evaluation of High Pressure Reactor

A New Method of Stress Linearization for Design by Analysis in Pressure Vessel Design

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

Finite Element Analysis of the Stress of the Offset Nozzles on the Head of a Liquid Tank

Modification Of Stress Linearization Method In Pressure Vessel Design

Finite Element Analysis and Optimization of Stress and Strain for Main Steam Pipelines

Finite Element Analysis on the Submersible Pressure Tank Structure Strength and Stability

Mechanical Stress Analysis of a 600 MW Supercritical Boiler Water Separator Based on the Finite Element Method

Stress Analysis and Evaluation of Special Shape Pressure Pipe

Calculations of Plastic Collapse Load of Pressure Vessel Using FEA

Stress analysis by BEM of axisymmetric vessels and pipes subjected to arbitrary distributed loads