Modification Of Stress Linearization Method In Pressure Vessel Design

Hong-Jun Li,Xun Huang

2015-01-01

Abstract:The difference in stress linearization method between EN13445 [1] and ASME VII-2 [2] is that the former linearizes all stress components, while for the latter, bending stresses are calculated only for the local hoop stress, meridional stresses and out-of-plane shear stress, and not for the local component stress parallel to the SCL or in-plane shear stress. ASME argues that the local component stress parallel to the SCL or in-plane shear stress doesn't produce moment action on stress classification lines. Although ASME VII-2 provides a more selective procedure in the methodology, linearizing the radial stress and in-plane shear stress will violate boundary conditions on the inner and outer surfaces of the vessel wall. This paper is devoted to improving existing stress linearization method and proposes a new method that the local component stress parallel to the SCL and in-plane shear stress use true values rather than linearized stresses in calculating the equivalent membrane plus bending stresses.